jayrock32580
Well-Known Member
Ok so I have a major problem. I have a 3 foot wide 2.5 feet deep 6 foot tall cabinet. It is lined with aluminum foil, no wrinkles or anything, I know somewhat cheap. I have one good plant growing in a aerogarden base with 4 inch airstone. Plant was doing great with the aerogarden lights, but i got a 250 hps. I took the aerogarden lights out put in the hps a 100cfm outtake fan 80 cfm intake. I got a 7 inch tabletop fan inside on high blowing from floor to ceiling. I have a 4 inch fan blowing across the top of the light, it is not a air cooled reflector. My humidity is 35-42% but my temps will not come below 89 during day and that is leaving door open. If I close the door it goes up to round 97. My fan leaves are droopy as can be with black spots all over and dry feeling. The plant is growing majorly still from all the nodes. Those leaves look and feel great. My ph is 7.1 so no problem there i know it is heat. I dont know how to bring temp down anymore though should i just increase to a 250 cfm outtake or just more intake little confused on where to begin there. Or should i do higher cfm outtake fan and do passive airtake holes on bottom? Any advice is helpful.