Bro you need cal mag..and maybe more nitrogen! COCO loves cal mag..remember, coco doesnt hold any nutes..you must refill it every day..just water plain phed water when your run off is 0.5 higher than what you put in and try to stabilize the ec where you want ..And in my opinion you should use some synthetic fertilizers..Generally coco needs more food than soil..what you use may be insufficient for the coco..Im using canna coco and it says its buffered. Using RO water mix with a little bit of dechlorinated tap water to raise ph to 6.5-6.8 and organic slow release fertilizer premixed in the soil. 4 weeks old
Before adding too much of anything, make sure you bring that ph down to around 5.8! Also with RO, and coco, you will need cal-mag with every watering! Are you using coco or soil? Slow release fertilizer doesn't help the equationIm using canna coco and it says its buffered. Using RO water mix with a little bit of dechlorinated tap water to raise ph to 6.5-6.8 and organic slow release fertilizer premixed in the soil. 4 weeks old
How do you come up with a guess like too much P? No mention of feed at all has been given! How does excess P differ from say excess K? Or maybe excess cal or iron is locking out Mg? Why do you say it's P when there is absolutely no info mentioned on what the feed is?I'm going to have to politely disagree and say you have too much P somewhere. Looks like a mag def, but it's too much P... In my opinion.
Also, I don't find calmag to be needed every time. Maybe every 3rd. Also, ph is fine between 5.7-6.5 going in.
Just my opinion.
How do you come up with a guess like too much P? No mention of feed at all has been given! How does excess P differ from say excess K? Or maybe excess cal or iron is locking out Mg? Why do you say it's P when there is absolutely no info mentioned on what the feed is?
The only reason it's mottled at the top is because either there is an issue with a heavier metal...but that heavier metal would be affected by an excess of any cation, not just P, or possibly some heat stress being the leaves are a bit curled over one section, maybe that part is right under the light or closest to it. So to look at a plant and say, it's too much P, without knowing anything about what has been put in, to me is not from experienceSlow release fertilizer, from OP.
I say it's P because I've had to adjust compost piles for that specific reason. Too much P causes that mottling at the top and the shade of the leaves... It just says P to me. Experience I guess.
The only reason it's mottled at the top is because either there is an issue with a heavier metal...but that heavier metal would be affected by an excess of any cation, not just P, or possibly some heat stress being the leaves are a bit curled over one section, maybe that part is right under the light or closest to it. So to look at a plant and say, it's too much P, without knowing anything about what has been put in, to me is not from experienceNot to mention, Op is not growing in compost, he's growing in coco/perlite. A bit of slow release fertilizer mixed in with coco is not going to overfeed, especially P, which is usually present in lowest amounts (npk). I would say for now, the biggest issue to fix first, is the ph! 6.5-6.8 is too high for coco, once that's done, then feed can be adjusted.
If it works for you, great, but you have the science completely off, thus leading you to make false judgementsCoco holds P very well. So everything else drains off and the P is still there.
If it works for you, great, but you have the science completely off, thus leading you to make false judgementsFirst off, P is not held strongly by coco, assuming that the P is even in a cation state, which depending on which other element it's bonded with, it can be a cation, or anion, in which case it will not be held at all. Calcium and magnesium have the strongest bond to cec sites in coco, then potassium and sodium. Phosphorus is not held strongly at all by coco! Anyways, with comments like science is bs, and you base it off what you see, without knowing key inputs, it would be hard to fully explain the logic behind it ): Best of luck in your grows!
im done dude, you clearly have no idea what im trying to explainhttps://growguru.co.za/blogs/hydroponic/buffering-coco-coir
Here, you like science.
Didn't even need science to tell me that. You can see it when you grow in it.
Now you say it lol. Either way, the bond between calcium or magnesium, and coco, is stronger than the bond with potassium..it's why buffering with cal-mag, will displace the potassium from cec sites and replace with cal or mag. Coco comes with a lot of sodium and potassium in it due to the areas they tend to grow in (near salt water), but the actual attraction of sodium or potassium, is not the strongest. Hope someone learns something from this rambling lol@Blitz35
I keep saying phosphorus and mean potassium, so you're right, but just replace phosphorus with potassium and that's what I mean lol.
im done dude, you clearly have no idea what im trying to explainThanks for the link, you proved my point!
Do a quick search, and you will see your link does not even contain the word phosphorus! lol. All you did with this link, was prove how wrong you were when you said "Coco holds P very well. So everything else drains off and the P is still there." Again, happy growing, it just sucks when false info is passed along to newbies from people who can't grasp the science of it
Good luck, happy growing!
Now you say it lol. Either way, the bond between calcium or magnesium, and coco, is stronger than the bond with potassium..it's why buffering with cal-mag, will displace the potassium from cec sites and replace with cal or mag. Coco comes with a lot of sodium and potassium in it due to the areas they tend to grow in (near salt water), but the actual attraction of sodium or potassium, is not the strongest. Hope someone learns something from this rambling lol![]()