Recent content by Fhawila

no i have not yet bought the light. i would love to control the light intensity as well as extras (ir + uv) with my arduino system that i am building. i think that MIGHT be possible with the digital controller using an analog adaptor for my arduino. i am also seriously considering the autopot...

thank you . i was watching the podcast of that guy growing over 1lb from an auto flower. INSANE he is using this light which i could get . currently my buds were too hot around 28.5celcius so i have lowered the ambient temp to 25 again. i think getting one of these lights is key to get...

thanks a lot noted on all the above . i’m using these lights https://www.bavagreenled.com/sale-13659283-sunlike-full-spectrum-greenhouse-grow-lamps-quantum-board-lm301h-240w-v4.html grow area / canopy is 196cm x 110cm i’m using two DWC systems 3 plants each. (but the chiller does move water...

if you had met my dad you would know a strong tone!!! :) your help is like the hand of god . i have been growing for 5 years and always struggled to get the mega yields i have seen elsewhere. Max i have gotten is around 170g per plant. I have hiked the ambient temps to 29 celcius ( i will...

legendary info. thank you. no reason as to why i have it at 600umol other than following a chart but forgetting to increase throughout flower. Note i also have two quantum LEDs beneath the plants facing upwards (see photo below it’s from a few weeks ago - now i have some good buds beneath )...

thank you for your detailed reply. I will check my leaf temperature offset tomorrow am. One issue is I have 5 different strains between two DWC systems so probably causing some nutrient issues. I have noticed that the EC goes up over time in the water so I assumed the plants were drinking more...

one of my plants still suffering , not sure why .

thanks a lot. attached is a VPD chart from one of my devices in the room. As for the epsom salts - what do you recommend for dosage ? thanks . plants seem to be recovering well. day time temp is back to 78.

thanks for your help . i will raise the day temp (has been on my mind) EC is currently at 2.2 will lower for a bit but doesn’t look like nutrient burn so much looks like calmag deficiency. i’m trying to grow 5 different strains so that’s not helping… RH i’m worried about raising to 60% due...

Hi guys , I’m running Mills nutrients - plants are particularly big as needed them to stabilise before flipping. 1.7-2 EC PH 5.8-6 600 uMol Quantum Led 66 F Water temp 73 F Ambient Temp 50% RH 1200 PPM CO2 Some plant leaves are showing these rust spots on them, I supplemented low dose...

yes temps were up to 90 F in the flower room . working on lowering that next run

Let the drying begin !!! thanks all for the tips. Pretty happy with the outcome. I did notice that there isn’t a very high amount of tricomes on the buds. Not that many crystals, could that be due to heat stress ? Or is that just organic growing ? Yield seems good. Will update.

Hey guys, are we ready for harvest ?

Ok awesome . also are you adding mycorrhizae to the mix , and how much ?

Also i have a question about your mix ! it seems to be around 150 gallons if i add up all the cu.ft and convert to gallons. If you have 4x20gal pots that’s 80 gallons. Am i missing something ? thanks !