Recent content by Knowledgeiskey

Thanks for the replys, heres some from today! Gonna veg longer try and pull some weight with this unknown bag seed strain?..

All good now, other plant was a male unfortunately. Will be cloning this one for sure hope its a good strain..

7 weeks old from seed, 50\50 coco, ewc. 3 gal smart pot. Dtw slow drip from res. 50%rh, 80-85~temp. 50 watt x 6 cree cob. 1.4-1.7ms Neptunes fish&seaweed 2-3-1, calmagic, ph5.6-6.2 Been upping the feed times thinking its a hungry one in the back..? Edit: bottom pic is one week earlier*

Hygrozyme or pondzyme helped me in a desperate time of need, after making a huge batch of zyme its part of my normal feeding. My space is cold also so i added a small heater set at lowest setting(500w) @68* at night, sealed room with lights on hits 79-82* plants look fantastic

run the water through some carbon or a brita, just need to add cal-mag epsom salt with air stone would make it better, my dehum sits on top of 20-gal black bucket with the line right into it with valve at bottom for use this is in the flower room edit: organic soil grow

Im growing some og kush/haze its a great strain! My nutes are ard 1500-2500ppm lots of cal-mag, ph of 5.6 and your urine will give it the natural "hot nitrogen fix" it might need

Dont drink the water or you'll be next..

Pax 3 is great and stealthy but im bias cause iv only owned one vape

Where's 2700k 80 cri and 3500k 80 cri on this chart

Building a far red supplemental coming along nice

I had a old advanced led diamond series 11-band led in the scrap pile, thought i rip out the drivers(well-lit driver couldnt find any info on these..) and test them, they kick out 75 volts.. long story short made a single 3590 3500k 80cri passive light for my veg room. I have one more heatsink...

Those led bulbs wont hurt the plants get close as you can use your hand to check the heat coming out the lamps shouldnt be much at all, maybe 3-5", try spreading the light to shine as many bud sites as possible

https://youtu.be/UqZMc6xZEF4

built this diy running water cloner using peat cubes and ph'd DO water from the res. Strain is: cali og kush/haze Light: 400watt 6x 3000k 90cri cbx3590

Why not grab some 100watt 3000k led cree bulbs from home depot take off the plastic diffuser and use a reflector, its what i did before buying high power cobs. also get a small 2x2 reflective tent for cheap on amazon or build one.. they look good and healthy though Good job