PSCsndmn313
Active Member
Sup everyone
This is my second time doing an aero grow. The frist time around i just used an AG and had some success but not much as far as yield was concerned. This time around Iv upgraded mostly everything and I have much higher expectations.
The strain that i am using is a locally grown strain that is suited for indoor grow setups along with the 3 part GH nutes.
Left Side Specs:
2x4 Mylar lined box
2 gallon rez with a 500 g/m pump and plastic sprayers
2 150w HPS placed 28' away from plants
2 30w florescent tube lights
2 6' fans for air circulation
10'x6' intake vent with filter
Right Side Specs:
2x4 Mylar lined box
AG
3w air pump with airstone
Plant Specs for Day 12:
PPM: 230
PH: 5.9
Air Temp: 77
I have had a few problems with our plants. When I started we placed the 150 HPS too close to the plants and they pretty much fried. I was also getting a water temp of around 95 so I dropped the lower half of the basin out of the light so we could control the water temp. The pics are of the two the survived but iv got 6 more germed and they are just about ready to sprout.
The only other concern i have is the minor yellowing on the inside of our newer nodes. Any info, comments or feedback on anything is greatly appreciated.
Enjoy the pics. More to come in a few days. I Just got my new Coolpix.
This is my second time doing an aero grow. The frist time around i just used an AG and had some success but not much as far as yield was concerned. This time around Iv upgraded mostly everything and I have much higher expectations.
The strain that i am using is a locally grown strain that is suited for indoor grow setups along with the 3 part GH nutes.
Left Side Specs:
2x4 Mylar lined box
2 gallon rez with a 500 g/m pump and plastic sprayers
2 150w HPS placed 28' away from plants
2 30w florescent tube lights
2 6' fans for air circulation
10'x6' intake vent with filter
Right Side Specs:
2x4 Mylar lined box
AG
3w air pump with airstone
Plant Specs for Day 12:
PPM: 230
PH: 5.9
Air Temp: 77
I have had a few problems with our plants. When I started we placed the 150 HPS too close to the plants and they pretty much fried. I was also getting a water temp of around 95 so I dropped the lower half of the basin out of the light so we could control the water temp. The pics are of the two the survived but iv got 6 more germed and they are just about ready to sprout.
The only other concern i have is the minor yellowing on the inside of our newer nodes. Any info, comments or feedback on anything is greatly appreciated.
Enjoy the pics. More to come in a few days. I Just got my new Coolpix.
