Arjan's Haze #1 / LED220 / грунт / GHE+Advanced Nutrients / LST

Hello, friends!
It is time for me to write a report. Prior to this experience and have raised two plants:

1) Aleftina - Auto AK от Grass-o-matic
2) Beatriche - Big Bang Auto от Green House Seeds

It's time to "raise" sativa. Meet! Calypso - Arjan's Haze # 1 from Green House Seeds (fem):

Type: Feminized cannabis seeds
Genotype: Sativa
Genetics: G13 x Haze
Flowering: 13 weeks
Yield: 900 g / m2
Height: 100 - 150 cm
THC: 18 - 22%
CBD: 0.2 - 0.9%
CBN: 0.7%

Arjan's Haze # 1 - hybrid genetics G13 x Haze has a very powerful, long lasting psychoactive effects and spicy mint flavor. The room fades for 11 weeks and has a yield of up to 600-800 g / m2, outdoors flowering ends in late October with a yield of up to 1.5 kg per plant. A large number of huge coles of the highest quality with a high THC content.

A few words about the environment where Calypso will grow:

Growbox:
1.20M * 0.6M * 2.5M (stylized wardrobe)

Light:
LED 220W - DIY 2 * 1 * + 3000K 4000K. On potlevel I plan to use UFO LED "made in china" 60W to bring the additional light to the root area.

Fans:
outtake- 100mm - 100M3/h fan (eventually plan to replace the S & P silent 350/125)
intake - passive
Plant will be blowed by the portable fan-on-clip

Filter:
The brainchild of Chinese iron industries. Will connect it during the stage of flowering.

Humidifier:
Ultrasound 5 L Orion (a shit)

Gauges:
Ph meter, TDS meter, timer - 3 pieces (lamps and valves). Meter for measuring electricity consumption
Microscope to determine the readiness of trichomes

Soil:
Polessky with coconut fiber, about 10-15% of perlite, vermiculite

Fertilizers:
GHE (General Hydroponics):
- FloraMicro, FloraBloom, Ripen fertilizer
- Ph Down to reduce Ph
- FloraKleen to remove salts from the soil
Advanced Nutrients:
- Tarantula to make another beneficial microorganisms in the soil
- Bud Candy stimulation yields
- Final Phase (analogue FloraKleen from GHE)
Pot:
12l bucket

Well, let's go?
March 5 seed was soaked in water. After 2 hours of "soaking" was placed under cotton pads and put in a non-transparent zip-bag
March 7 baby woke up and was planted in a pot. The landing place was covered with glass to simulate the greenhouse. The light was turned on for 24 hours for the germ. After that, I plan to switch the light on 18/6 mode for the entire period of vega growth.
The temperature in the box is too hot due to the LED light generating heat. I have to fight it all the way out.

Dear friends,

I want to update you on the recent status.

March 9 Calypso came to the surface. To be continued... Thanks to everyone who participates and monitors the data reports.

P.S. And I decided to grow lettuce and celery, they are at oblong container on the right

9 days from the seed, 0 days of vega, 0 days of preflowering, 0 days of flowering

And hello again!


It's been almost a week since the previous report. Subjectively Calypso stunted. I have decided to keep 24/0 in the beginning of the cycle and gave a reduced lighting. The DIY LED light ia new creature and I had to learn its capabilities. Therefore, to apply precaution. Now more:


March 10 Calypso was poured pint of water (pH 6.1) with tarantula (A&N) (1ml / liter) and zircon (0.1 ml / liter). Was poured at a certain distance from the roots of the plant to motivate them stretch to moisture and develop faster.

March 11 Soil has been added to the pot to cover the plant, as Calypso stretched for about 3-4 cm.

March 13 Calypso was poured by a 1 liter of water (pH 6.1) with tarantula (A&N) (1ml / liter) and zircon (0.1 ml / liter).


Photos are made today, and I was confused by the drooped leaves. I do not want to pour and do not want to keep it dry. But perhaps have to add more...

Struggling with the temperature in the box. When the lamp has 100% of power the temperature is 30. I do not know what I would do in the summer. need to think about the active intake and more powerful outtake. The distance from the lamp to the plant - 64cm.

Will appreciate to receive your comments and suggestions about the current status.

Well, my pet has put her "arms" down. First of all I thought that it is because of massive watering I made, but here's the thing. I poured water on the distance from the plant. But the soil under it became dry. Yesterday poured some water (60 ml) right to the root area and 1 hour later it lifted "hands". Concluded that watering from the distance should come later. In the meantime, I need to feed it with water right to the root area but with a little ammount. Not sure that the root cause is 100% true. I have other factors which mey lead to this situation (heat and high humidity). As the doctors say, it is necessary to observe.

P.S. I apologize for the frequent comments, but it had to be memorized for the new generation :!

11 days of germination, 0 days of vega, 0 days of preflowering, 0 days of flowering

Comrades,

Plans vary slightly. At this stage of development of the plant she needs enhanced care, so I will write more in the report during vega. State of the plant has improved since I started watering it at the root. Nevertheless, the color of the leaves is far from ideal and reminds pale green. Fertilize not yet logical, quite early yet. On the other hand it seems that it lacks the fertilizer (N).

Please estimate the progress at this stage of its development.

Also, do not give up on your comments about the "ragged" leaf at Calypso (causes, effects). It marked in red in the picture.

From tomorrow to begin to consider vega for Calypso.

16 days of germination, 5 days of vega, 0 days of preflowering, 0 days of flowering

And hello again,

I have again not good news. The first pair of leaves gets dry and the reason for this (90%) is overwatering.
I decide to dry Calypso and to limit watering.

Congratulations, Dad, you have a girl. Our baby showed the sex and I very much hope that she escaped.

Now I try to buy a new vent because vent purchased from Grow shop died.
I did watering 2 times (19 and 20th) for 100ml since the last report.
Below you will find a photo report. As always, look forward to your comments and suggestions.

P.S. Have you noticed that the salad and matiola grow. But celera stubborn

You need more RH. 34% is low for germinatin.

ethabhae said:

You need more RH. 34% is low for germinatin.

Click to expand...

now trying to increase the pH up to 6.5 at least. humidity is 40-60 now.

21 days of germination, 10 days of vega, 0 days of preflowering, 0 days of flowering

So we continue our report,

Plant slowed the development due to overwatering so that lower leaves began to dry out. The condition of Calypso got better during the dry. But it is not possible without the probblems and solutions in my grove.

Leaves began to change pigmentation. The tops began to eat Nitrogen of older brothers (lower leaves).

(First picture attached)

Therefore started to add fertilizer. 50% of the feed standard: GHE Micro 2.1 mg + GHE Bloom 2.3 mg

Ie this set of fertilizers breed not 1 but 2 liters of water. First Micro thwarted, and then bloom. Otherwise, it may fall out sediment.

Bought a vent Soler & Palau 250/100 (31dB) and connected it. The device is buzzing even at low speeds. Will change to Soler & Palau 250/100 Silent (24dB).

So, let's continue. Plants do not have enough nitrogen and it was decided to add it there. Growth has accelerated and plant came up. Expect delay behind schedule for 7-10 days.

But that's not all, there were spots on the leaves and I smoke forum looking for answers ...

Pictures 2-5 attached

Watering small portions of 100-150 grams per day or every other day. Guided by the weight of the pot, which in the dry state 5.8 kg. Weighing spend regularly for the report.

23 days of germination, 12 days of vega, 0 days of preflowering, 0 days of flowering

Hello gardeners!


Was forced away for the weekend. And immediately came to see my pet. Fuck ... Calypso gets worse and worse. I - flayer

Before leaving, spilled water and fertilize and went into another country. Today I saw this (first 3 pictures)

Judging by appearance - deficiency of potassium and just in general.

But confuse me lower leaves. Nothing similar I can find in the forum (pictures 4-5).

Found this - burn light. It is even possible?

http://www.growweedeasy.com/cannabis-light-burn

Please help, because he can kill a petl at all Last time watered Calypso on friday by a solution for vega 100% 2L. inlet pH was 5.9 and the exact output. The soil in two days is still wet.

26 days of germination, 15 days of vega, 0 days of preflowering, 0 days of flowering

Back to our room ...

Decided to share the good news. Calypso revived due to slightly improved pH. It's not perfect, and the last time was 6.2. Plans to raise it up to 6.5-6.7.
Now the soil is still wet so the correction of pH is delayed. As can be seen in the pictures, new floors and Calypso began to grow in breadth. There were lateral branches.

Pictures 1-2

I also plan to add a little more soil till the first leaf. Will add soil almost till "web".

Picture 3

Today took its exhaust fan. Was surprised by its size. Everything is clear, silence requires size.

Picture 4

Also there is news from my garden. Lettuce grows and Celera also trying to catch.

Picture 5

30 days of germination, 19 days of vega, 0 days of preflowering, 0 days of flowering

Again, I welcome you in my stead!

During our separation with my pet occurred marvelous metamorphosis. Calypso clearly benefited from the increased pH and began to grow. Did a LST.
For who do not know (beginners), this means Low stress training:

Workout with minimal stress (LST), a method which is a method of controlling the growth of marijuana plants with "minimal stress." LST includes techniques such as bending, tying, which let you create the shape of your plant. LST also can trim your plants.

Pictures 1-2

The dry residue: LST help control the growth rastihi and enable it to form the shape (to push the stems) to more branches gained access to the light.
In the photos you can see that the food is not supplied in sufficient number I, and I think all of this fault block of fertilizer.

Picture 3

Therefore, on Saturday, decided to shed CAlypso again to raise the pH and spent on the case 10 liters of water. As a result, managed to raise as much as 0.2 pH. During the strait did calibration of pH-meter and found that he was lying on top of 0.1, ie, from all my previous measurements need to take 0.1.
This is understandable why plant was so bad. As a result, the strait of 10 liters of water to get as much as 6.3 out and then water was over. Next strait will do when the soil is dry. Concluded that my water ok and I do not need to acid it as fertilizers will correct it to 6.5-7.

Picture 4

Noticed the strange behavior of the leaves at the top. they jum clockwise. Nothing of the sort found in Internet and will be glad to hear comments...

Picture 5-6

Oh, and I hung new fan in my "closet" and he very well there. noise is not reduced, but now more airflow. It turned out that kanalnik has removable sleeves and modified to a diameter of 125 mm on both sides (now 100mm), which will pave the ducts of large diameter. This will reduce the noise.

Picture 7

Did not close the switching box on fan, because want to buy a switch (switch) that allows switching between low (low) and elevated (high) air supply.

up

Hello alef, some cal/mag might help

follow ph and EC 'ppm' i see deficiency and nute burn same time dont over water, i think you should flush yur medium with RO water..

You're over loving in my opinion back off the nutes, back off how much your watering / giving nutes cause it looks over watered too.