BHO Purge

hi everyone. I made the mistake of lending out my vac pump and of course it came back dead. So I will be without until a replacement can be acquired economically. :-/

I am about to blast a 1 Oz glass tube into a Pyrex dish followed up by a hot bath purge.

Now many scrape it up from here and smoke it. Some will let it sit in the plate for several hours to days then smoke it and then some will still scrape it and heat it some more.

I have my vac chamber and access to a small vac pump but it is only able to achieve a vac of 22” not the nice 29.5 with the larger vac.

My question is will this still purge under this vac strength with heat applied? Or should I just bath purge and let it sit for a few hours/days etc and purge that way.

Any help would be appreciated. It may be a week or two before new pump comes. I cannot wait hence my question.

Any positive input/thoughts will be appreciated.

Thank you
Venge

These are my photos:

Initial blast into pyrex bowl, then warm water bath
Then scraped onto parchment for vac chamber
Muffin pic
I did a flip and squished it to flatten and even out so more butane can escape. Want to get as thin as possible. The thinner the easier for butane to be released.
Hopefully that is not a nose hair in the 1 pic.
And final pic is me picking it up to flip. Still very sticky but firming up a bit.
Wish I had stronger vac pump to finish off proper.
Either way looking good. Will leave under low temp and vac at 22”. For another day with a few more flips. Cause I have to play.

Venge