Drying Tent Setup

Hi everyone.. I’m preparing to chop 3 of my plants that are ready for harvest, but I still have other plants currently flowering in the tent… I have another 2x4x6 that I am considering converting to a drying tent.
I’m assuming that the plants moisture is going to keep the humidity inside the tent jacked up and I should only require a dehumidifier and a small fan to circulate air, plus an exhaust/scrubber at the lowest setting. I’d like to put a dehumidifier INSIDE the tent, but my concern is if I put a dehumidifier directly in the tent, will the warm dry air that comes out be too much air movement for the drying process? Can anyone recommend a small dehumidifier that I can run off of an INKBIRD humidity controller that won’t move too much air? Or does anyone have another idea that might work?
ambient temps in the area are around 70-72, I know not ideal but it’s what I have to work with…

I just use my ACI controller and. 4INCH Inline exhaust/ filter. Use either humidity or VPD as your trigger.

I don't think the air movement will be too much from the dehumidifier.

I'd use an air conditioner and possibly a dehu in the room, not blowing warm air on the weed.

Depends where you live. I have to use a humidifier to keep it at 60%

I am close to doing the same thing but I am not so sure I will need humidity or will need to reduce humidity so I am planning for both. My lung room is at 35% and is pretty stable. I have the ACI humidifier and heat box and can get 65 and 62RH with very little waver.
Just make sure your setup lets you move both ways.

My lung room is pretty dry right now.. it’s about 20-25%. I run an ACI humidifier in my tent to keep proper humidity levels during flower. I’m still going to need the ACI in my flower tent while the drying begins but have an INKBIRD and humidifier that i can use if needed. Hopefully I can dial it in and get as close to 60/60 as possible