Hello everyone

Hey, Newbie indoor grower here. I’ve done well with outdoors but this LED indoor stuff is a huge learning curve. I’m used to putting plants in a field in may and going back to harvest them in October. I have to tend to the every need of the plant now, LOL. This site has been a great help so far. I’ll hopefully find the ambition in the near future to add to my story but it’s been a long day of steamwhistles and bongs so I’m off to bed.
Cheers

Welcome to RIU!

Thanks for the welcome. I’m not sure where to post but I thought I post about my grow tent and maybe get some input from more experienced growers.

I have
-vivosun 4x4 tent
-Mars fc4800 about 30” above the canopy
-California light works UVB in the middle of the Mars
-Three 6” clip in fans in the corners
-super simple co2 controller in the last corner
-4plants
-co2 rain tubes run in an X about 7” above canopy
-green led nightlight
-small space heater
-mist/vapour humidifier (not used for awhile)
-4” USB fan above my driver blowing straight down
-hydro-x controller
-growing in fabric pots with stepwell soil/veg dressing
-ph water to 6.3ish

I have the lights on a 18/6 schedule with the UVB coming on for 1h, off for 40min, then back on for 1h in the middle of the day cycle. The Mars is dimmed to about half. The fan above the inverter and one of the corner fans are on 24/7 while the other two go off with the lights. The co2 is set to about 1100ppm.

I have two AgroLED (I think) veg spectrum 24” sun blasters that I’m going to hang between the Mars on either side of the uvb. I’ll have them on the same timer with the Mars. I’m looking in to getting a couple 730nm pucks for the start of the sleep cycle and am debating on also adding some 680nm and running them with the 730nm for a little bit before night.

that’s it summed up. I’ll try and post some pics once I get everything picture worthy.