Micro Nute addition

So here is a question I cannot find an answer to, You have to add Micro first before Gro and Bloom, and I am always extra careful and add Micro then wait a half hour while I do other stuff before adding the other two nutes, but question is, after I have added all 3 parts and my PPM is not where I want it, can I then add more Micro to the solution after its been mixed? Or could that cause lock out?

you could mix it stronger and then dilute with water to hit target ppm

if i had to add more micro, i'd dilute it in a gallon or so of water and then add to the res.

Bron-Y-Aur Stomp said:

So here is a question I cannot find an answer to, You have to add Micro first before Gro and Bloom, and I am always extra careful and add Micro then wait a half hour while I do other stuff before adding the other two nutes, but question is, after I have added all 3 parts and my PPM is not where I want it, can I then add more Micro to the solution after its been mixed? Or could that cause lock out?

Click to expand...

First off there's no reason to wait before adding more nutes and 2nd just go ahead and add more later if it's not where you want it at first. All the years I did DWC I just added small amounts of nutes to keep my ppm at the level I wanted and never had any problems. That was also when never doing a nute change for the whole grow and the water would be clear with no sediment in the bottom of the tubs when the grow was done.

Do an experiment. Mix up some nutes in the proper order in something like a mason jar then add some more micro and look for sediment.

Bron-Y-Aur Stomp said:

So here is a question I cannot find an answer to, You have to add Micro first before Gro and Bloom, and I am always extra careful and add Micro then wait a half hour while I do other stuff before adding the other two nutes, but question is, after I have added all 3 parts and my PPM is not where I want it, can I then add more Micro to the solution after its been mixed? Or could that cause lock out?

Click to expand...

Micro's not all that prone to precipitation. Just add it and immediately add your grow then bloom, assuming you're using GH Flora three part. Also make sure you have a good gallon or so to add it to.

Bron-Y-Aur Stomp said:

So here is a question I cannot find an answer to, You have to add Micro first before Gro and Bloom, and I am always extra careful and add Micro then wait a half hour while I do other stuff before adding the other two nutes, but question is, after I have added all 3 parts and my PPM is not where I want it, can I then add more Micro to the solution after its been mixed? Or could that cause lock out?

Click to expand...

The answer is yes. You can add more Micro. Mix well first and no problem, just in moderation.