Pdxelectrician
New Member
So, I have a large reservoir and a 1300gph waste water sump pump that is pumping into 1/2" line that Ts off into two tables. After it Ts off, it goes to a table with 4 plants. It Ts twice to feed 4 plants off one line feeding the table. It then goes into a feeding ring that has holes in it to feed the plants. The system is perfectly symmetrical however, there is always one ring that doesn't get the same water.
I'd use a 4 port manifold however
is there options that would help me make this feeder system consistent and clog proof? Also are there stakes that will spread the water out as it runs into the pot. With one feeder line, I'm afraid the water will carve out a path and won't spread throughout the pot and just run quickly out the bottom.
using drain to waste scrog with Ready Grow aeration formula. Thanks everyone. First post BTW
I'd use a 4 port manifold however
- I don't like how small the ports are for them and I'm afraid they will clog
- its tough to get one feed to cover a large 10 gal pot and feed evenly
- its tough to get all the small feeder lines the same length coming off the manifold to make for even flow
is there options that would help me make this feeder system consistent and clog proof? Also are there stakes that will spread the water out as it runs into the pot. With one feeder line, I'm afraid the water will carve out a path and won't spread throughout the pot and just run quickly out the bottom.
using drain to waste scrog with Ready Grow aeration formula. Thanks everyone. First post BTW