hmmm123
Well-Known Member
LOWRYDER 2 GROW
My last grow went horribly wrong, that's if you can even count it as a grow only made it up to about 2 weeks and all my plants where dead! Hoping to do better this time around though. They say you learn from your mistakes so we will see how things go. Any input along the way would be great though!
Basic information about my setup.
I will be trying to grow lowryder 2 again. Going to be growing indoors indside my cab,(which is in my wardrobe.) My cab mesures about 60cm high, by 40cm wide and 30cm deep. (Hoping this is going to be big enough to grow a couple of lowryers in.)
Lighting.
For my lighting i have invested in a new cfl grow light. My cfl bulb is 125watt dual spectrum bulb which means it has both the red and blue spectrum light in it so i should be able to use the same light from start to finish i hope. Unlike most people who have there lights so they can be ajusted i have mine fastened in one place, but instead i have a shelve that i will lift to the right hight and place my pots on there seemed like the best option at the time seems to be working ok so far. Think i prefer it because i know my light is fastened solid and is very ulikely to fall down with it setup this way. Only have the one light so far will get more later on if needs be.
Air flow.
For my intake i'm using a pc extractor fan at the bottom of my cab wired to a 12volt adapter. For extracting the hot air i'm using a 100mm bathroom extractor fan wired to a normal 3amp plug. The fans are a bit loud really but i have managed to quiet them down a bit by warpping foam around them. Also i have made my bathroom fan a bit quieter by getting a piece of plastic pipe slightly bigger than my fan and placing it over my fan then putting some more plastic around that pipe with a gap about inch big inbetween the two bits of pipes. I then filled the gab between the two with cotton wool to help with vibrations. This just slides in and out so when i need to add a carbon filter later on, i can just slide it off put my filter inside the pipe and slide it back on again.
Will update later on my plants when i have taken some pics, thought i'd start off with the setup first.