Nutrients Mixer

ruwtz

Well-Known Member
I pull out the hose and just run the pump when i'm reloading. Does the trick just fine.

Some people run a separate pump just for recirculation, keeping the solution agitated by running it on a cycle timer.
 

ruwtz

Well-Known Member
Some people run a separate pump just for recirculation, keeping the solution agitated by running it on a cycle tim
When you say pump you mean air stones?
No I mean a pump. Stick a short hose on a small pump - say 76gph - to simply recirculate the res occasionally. Say, 5 mins every half hour or something.
 

SvenskiDWC

Member
put a submersible pond pump in the reservoir and run it when you are mixing, and you can leave it running to prevent settle out while the mix sits
 

SvenskiDWC

Member
Fair warning though -- if you leave a pump running in the reservoir indefintely, it will generate some heat (although very minor when sized correctly). So if you want to leave it on permanently, make sure the pump is appropriately sized for the volume of your rez... ie don't put a 1100 gph submersible pump into 40 gallons of water
 

Shugglet

Well-Known Member
Fair warning though -- if you leave a pump running in the reservoir indefintely, it will generate some heat (although very minor when sized correctly). So if you want to leave it on permanently, make sure the pump is appropriately sized for the volume of your rez... ie don't put a 1100 gph submersible pump into 40 gallons of water
Use an aquarium circulation pump and you won't have that problem.
 

SvenskiDWC

Member
Use an aquarium circulation pump and you won't have that problem.
Would work well too, I don't have any problems with heat generated by the submersible, water temps sits nicely below (or at) 60F. I'm using a laughably small pump to keep the reservoir agitated . Any electrically driven motor will impart heat into the tank, except maybe those fancy split circ pumps that use magnets and the motor body is outside of the aquarium (but are magnetically driving the propeller in the tank).
 

Shugglet

Well-Known Member
Would work well too, I don't have any problems with heat generated by the submersible, water temps sits nicely below (or at) 60F. I'm using a laughably small pump to keep the reservoir agitated . Any electrically driven motor will impart heat into the tank, except maybe those fancy split circ pumps that use magnets and the motor body is outside of the aquarium (but are magnetically driving the propeller in the tank).
I dont know what yours is, but I have a circulation pump in my small setup that moves 800GPH while only using 6watts.
 

mjinc

Well-Known Member
If you have a 50 gallon res try a battery hand drill with a paint mixer extension. Makes the job a breeze
 
Top