Airwalker16
Well-Known Member
I don't know what you meanis my math right on that? 1300 mW in, 18 mW out, ~1.5% efficient?
I don't know what you meanis my math right on that? 1300 mW in, 18 mW out, ~1.5% efficient?
Where's it say power out?power in = 200 mA x 6.5V = 1300 mW
power out = 18 mW
18/1300 = 1.38%
Just curious - what would you consider to be cost effective? What $/watt and what lifespan would it take to get you interested?they always were, but are they actually cost effective now?
im not sure what efficiency the tubes run at, but their output per $ is prob less than 10% of the LEDsJust curious - what would you consider to be cost effective? What $/watt and what lifespan would it take to get you interested?
Edit: Silly me. Also, what kind of efficiency would you be looking for?
I suppose it's a question of whether or not the lifespan of the LEDs would make the price worth it, compared to a fluoro fixture that requires bulb replacements.im not sure what efficiency the tubes run at, but their output per $ is prob less than 10% of the LEDs
the only advantages the LEDs would have is efficiency or cost but doesnt seem its there yet
That seems to be what the data sheet says. Get the UV tubes.is my math right on that? 1300 mW in, 18 mW out, ~1.5% efficient?
Yea, sun glasses, long-sleeved clothings and gloves are a must or you have to turn it off each time you enter the room!ill never ever sell or rep uv diodes or tubes.
too much chance for user error. you only get one set of eyes
ill advise but dont want to be responsible for that
scary enough to be responsible for noobs doing their first electrical project :/
I believe the UV-A in reptile bulb is a plus.One would need a lot of these diodes to get comparable output like a UVB/A tube. A 4ft./54w Agromax tube at 1' delivers 440mW/cm² and her footprint is ~4x 2' or 0,72m². At 2' it's still 170mW/cm² and the footprint would be ~4x 4'.
UV light causes some changes within the plant, an immune reaction is triggered as well as some defense mechanisms.
Below is a UVB chart for natural UVB strength in summer. I would say these Agromax tubes fits very well. As mentioned earlier in the thread I would run it on a separate minute timer. It's very easy to damage you plant with 440μW. I've used ~125-150mW/cm² for the whole day with good success(39w Arcadia reptile bulp, 12% UVB, 4x 2' tent).
Not a single damage on the leafes but I found a few seeds and they are already deformed (one BlueDream hermied).
I'm pretty sure they could handle even more maybe 200 or up to 300μW without getting damaged.
But one should watch the girls well. Burnt leaf margins and tips are first symptoms that its too much. Twisted leafes and other deformings means it's much too much.
Plants should get used to UVB radiation as early as possible. I've used half the intensity already in veg.
At the beginning they got 2+2 hours UV light (with lights on and before lights off) and I increased it weekly until I ran it for 12/12 in bloom week 7.
Next time I will increase it faster and start already with 2x 3h and ~100-150mW a day, from bloom week 5 I will use up to 250mW the whole day. If damages occur I will reduce it untill the damages dissapear.
View attachment 4167553 View attachment 4167568
The Pure UV bulb from Agromax is 75% UVB and 25% UVA. Rather than both UVB and UVA being around 10-15% of the whole Reptile Bulbs output.I believe the UV-A in reptile bulb is a plus.
Yea, it is! But usually these tubes all produce both typs of UV radiation + some visible light. The UVA output is almost stable over time but the UVB output decrease by ~30-35% every 1000h of usage. The good thing with the Agromax bulbs is even after 1000h of usage they make more usable UVB like a brand new reptile bulp(max. 14% UVB, Arcadia D3dragon).I believe the UV-A in reptile bulb is a plus.
Last crop , I noticed some seeds with exactly this kind of deformation… The mother was a sativa, normally it produces nice elongated médium size sedes...but this time I saw that some sedes were broader...like indica ones and some of them have this deformation...exactly the same.. I did not know the reason..and was tempted to post about it… Well i know why now… And yes I used 10 hours a day a compact reptil uvb… Little but the high uvb producer I found in Spain about 15%. So I see I was using too much uvb.. mostly cause I do not move the uvb lamp to other places in the tent like in other crops..lazy man I was….One would need a lot of these diodes to get comparable output like a UVB/A tube. A 4ft./54w Agromax tube at 1' delivers 440mW/cm² and her footprint is ~4x 2' or 0,72m². At 2' it's still 170mW/cm² and the footprint would be ~4x 4'.
UV light causes some changes within the plant, an immune reaction is triggered as well as some defense mechanisms.
Below is a UVB chart for natural UVB strength in summer. I would say these Agromax tubes fits very well. As mentioned earlier in the thread I would run it on a separate minute timer. It's very easy to damage you plant with 440μW. I've used ~125-150mW/cm² for the whole day with good success(39w Arcadia reptile bulp, 12% UVB, 4x 2' tent).
Not a single damage on the leafes but I found a few seeds and they are already deformed (one BlueDream hermied).
I'm pretty sure they could handle even more maybe 200 or up to 300μW without getting damaged.
But one should watch the girls well. Burnt leaf margins and tips are first symptoms that its too much. Twisted leafes and other deformings means it's much too much.
Plants should get used to UVB radiation as early as possible. I've used half the intensity already in veg.
At the beginning they got 2+2 hours UV light (with lights on and before lights off) and I increased it weekly until I ran it for 12/12 in bloom week 7.
Next time I will increase it faster and start already with 2x 3h and ~100-150mW a day, from bloom week 5 I will use up to 250mW the whole day. If damages occur I will reduce it untill the damages dissapear.
View attachment 4167553 View attachment 4167568