Inventronics eud-240s320DT

[chatoo123]

I want to know about this driver I know it's a really good driver has programmable 3in 1 dimming 0-10 vt , pwm, time dimmable type.i read the manual and it says it's set to 0-10 volt dimmer at default I'm glad because I don't have a pic to hook it to let alone the inventronics programmer it says it has a end 15 timer I bet it could be used for a far red initiator I (think) I have 2 of these I know someone out there knows about this driver hopefully I can get help about it. I'm am gonna use for 2 Vero 29 se's 3500 k 51 volt ones I'm hoping when the 0-10 volt dimmer comes it will work. Because I hooked it up the first time with a 100k pot and it was so dim it wasn't right well I looked and from what I understand it has to be hoooho up to the 0-10 volt dimmer to work fully cause that's what the driver is set at inside....

 

[redeyedfrog]

Go here, those folks know the deal!
https://www.rollitup.org/f/led-and-other-lighting.124/

 

[GBAUTO]

from what I can decipher from the Inventronics website, it looks like they operate just like a Meanwell. With the dim leads either disconnected or over 100k resistance, it should go to full output. When the resistance across the dim leads drops to zero, it will reduce output to an off or idle.

 

[chatoo123]

from what I can decipher from the Inventronics website, it looks like they operate just like a Meanwell. With the dim leads either disconnected or over 100k resistance, it should go to full output. When the resistance across the dim leads drops to zero, it will reduce output to an off or idle.

from what I can decipher from the Inventronics website, it looks like they operate just like a Meanwell. With the dim leads either disconnected or over 100k resistance, it should go to full output. When the resistance across the dim leads drops to zero, it will reduce output to an off or idle.

I hooked 2 50volt Vero 29ses to it and it barely even lit em up from what I can find is it says u gotta hook it to a programmer but it's set to default 0-10 volt otherwise it outputs the minimum

 

[GBAUTO]

I did see in the spec sheet that if the unit is programmed to PWM dimming and the dim leads are left disconnected it will output minimum. It wasn't very clear on how to change the settings. I would contact Inventronics and see if they can walk you through it.

 

[chatoo123]

Th

I did see in the spec sheet that if the unit is programmed to PWM dimming and the dim leads are left disconnected it will output minimum. It wasn't very clear on how to change the settings. I would contact Inventronics and see if they can walk you through it.

Thanks for the reply im waiting on a 0-10 volt dimmer to come