Are these pollen sacks?

xmplr

Active Member
What pH are you feeding at?

What % of the recommended values of nutes are you giving.
I’m slowly lowering it right now coz run off ppm was way to high. from EC 2.0 slowly going down to 0.4-0.6 and then build it up again up to 1.6-1.8 maximum and keep it there.Or should i right away flush with 0.4 0.6? I did have a bit of a burn so i’m trying to fix it now.
 

Red Eyed

Well-Known Member
Are mites only prone to certain areas or they found throughout the world....also, would a grow be more prone to mites if it's in a basement compared to a bedroom?
 

Herb & Suds

Well-Known Member
Are mites only prone to certain areas or they found throughout the world....also, would a grow be more prone to mites if it's in a basement compared to a bedroom?
They can be anywhere but
Most commonly they come on a clone someone gave you :wall:
 

Red Eyed

Well-Known Member
They can be anywhere but
Most commonly they come on a clone someone gave you :wall:
I always see people here with mite problems yet never once had to deal with them....I also make sure not to drag pests into my area from outside. Always wondered how people get them so easily.
 

kovidkough

Well-Known Member
I always see people here with mite problems yet never once had to deal with them....I also make sure not to drag pests into my area from outside. Always wondered how people get them so easily.
I tried to veg some plants outside this summer, ya know free electric and all...bad ideaaaa
 

JustBlazin

Well-Known Member
could just be your ph being off and making your nute uptake go out of whack
i dont grow in coco but i think you want ph to be 5.8
hopefully someone who grows in coco can chime in
 

JustBlazin

Well-Known Member
Any idea? Ph 5 it’s happening to a few of the plants where bottom leaves are yellowing. Nitrogen deficiency?
first pick looks kinda like N def, but the second pic looks like it has more issues than just N def..but hey take that with a grain of salt im no expert by any means
 

xmplr

Active Member
I’m slowly lowering it right now coz run off ppm was way to high. from EC 2.0 slowly going down to 0.4-0.6 and then build it up again up to 1.6-1.8 maximum and keep it there.Or should i right away flush with 0.4 0.6? I did have a bit of a burn so i’m trying to fix it now.
Do i slowly lower the EC or do go from EC 2.0 to 0.4 since i wanna flush?
 
Top