The Daily Nugg,

Favorite time to smoke

  • Morning

    Votes: 69 24.0%
  • Afternoon

    Votes: 26 9.1%
  • Nighttime

    Votes: 68 23.7%
  • Naked while yelling at strangers

    Votes: 124 43.2%

  • Total voters
    287

tyler.durden

Well-Known Member
ROFLMAO, but you spelled it wrong so they may never know. She'll dial it in. LOL Not all of us are skilled enough to slide down a staircase on our bum! This Wedding Cake is really nice. I may keep it
I didn't spell it wrong, they did ;)
Just because she doesn't feel the need to wait for them to turn legal drinking age before we move them to our substrate of choice doesn't mean something something, damn it.
Two responses to one post, I'm just that good...


blowing guns gif.gif
 

curious2garden

Well-Known Mod
Staff member
Technically two roots... a good marketing exec could spin this into 50% more roots.

I'm thrilled, I thought they were dead for sure. I'm 1/3 of the way there.
Here they are after getting their feet adjusted to coco. They shoot up past their miserable looks and the once golden clones turn green again. I still have a good 8-10 weeks before I'm ready for them on my flower table so I need them to go slow.
1614529537637.png
 

RastaDud

Active Member
Hey guys would like to share with a little bit of my new enterprise on growing.

Secret Bathroom Garden Fortress

I was very surprised after managing to perfectly fit 33 of 2.5 litres pot

Will do 12/12 running from seed for the most of them...only taking a part 6 to veg for extra 6 weeks

Genetics are a mix of 15 pure Blue Dream; also 15 Blue Dream crossed with different pure Sativa landrace from Brazil; 2 Critical Kush from Barney's... and 1 Super Bud from GHS

Setup used: currently on 250W MH lumatek ballast...adding 400W HPS in 2 or 3 weeks till end of flower

Media is a very light mix of soil + coco fibre + perlite

It's growing super fast as Hydro but yet with the forgiveness of soil grown

I call it HydrOrganic
20210228_130725.jpg20210228_130713.jpg20210228_124149.jpg
 

curious2garden

Well-Known Mod
Staff member
Hey guys would like to share with a little bit of my new enterprise on growing.

Secret Bathroom Garden Fortress

I was very surprised after managing to perfectly fit 33 of 2.5 litres pot

Will do 12/12 running from seed for the most of them...only taking a part 6 to veg for extra 6 weeks

Genetics are a mix of 15 pure Blue Dream; also 15 Blue Dream crossed with different pure Sativa landrace from Brazil; 2 Critical Kush from Barney's... and 1 Super Bud from GHS

Setup used: currently on 250W MH lumatek ballast...adding 400W HPS in 2 or 3 weeks till end of flower

Media is a very light mix of soil + coco fibre + perlite

It's growing super fast as Hydro but yet with the forgiveness of soil grown

I call it HydrOrganic
View attachment 4839812View attachment 4839814View attachment 4839816
Where do you plan to flower all those?
 

raratt

Well-Known Member
Hey guys would like to share with a little bit of my new enterprise on growing.

Secret Bathroom Garden Fortress

I was very surprised after managing to perfectly fit 33 of 2.5 litres pot

Will do 12/12 running from seed for the most of them...only taking a part 6 to veg for extra 6 weeks

Genetics are a mix of 15 pure Blue Dream; also 15 Blue Dream crossed with different pure Sativa landrace from Brazil; 2 Critical Kush from Barney's... and 1 Super Bud from GHS

Setup used: currently on 250W MH lumatek ballast...adding 400W HPS in 2 or 3 weeks till end of flower

Media is a very light mix of soil + coco fibre + perlite

It's growing super fast as Hydro but yet with the forgiveness of soil grown

I call it HydrOrganic
View attachment 4839812View attachment 4839814View attachment 4839816
You know you need to reduce the amount of time the lights are on to get them to flower right? I run 18/6 until I want them to bloom, then 12/12. Edit: I guess 12/12 works.
 
Last edited:

Laughing Grass

Well-Known Member
Rollitup Advertiser
Here they are after getting their feet adjusted to coco. They shoot up past their miserable looks and the once golden clones turn green again. I still have a good 8-10 weeks before I'm ready for them on my flower table so I need them to go slow.
View attachment 4839641
How long ago were those cut? And are you still taking your clones in flower?

Another one made a root over the weekend. That's two now lol. This is one of the clones that I took at three weeks flower. :confused:

IMG_0040.JPG
IMG_0041.JPG

I think I cloned the wrong plant lol. The one on the left is making fat buds.
IMG_0039.JPG
 

curious2garden

Well-Known Mod
Staff member
How long ago were those cut? And are you still taking your clones in flower?

Another one made a root over the weekend. That's two now lol. This is one of the clones that I took at three weeks flower. :confused:

View attachment 4840537
View attachment 4840536

I think I cloned the wrong plant lol. The one on the left is making fat buds.
View attachment 4840538
Yup still taking my clones in flower. I try for week 2, usually hit three and occasionally go a tad later. I'll check the date when I get upstairs later.

Also add water until it touches the base of your sprayer bars. Your pump is heating your water up too much. More water will act as a temp buffer. However I'd still add KLN
 

Laughing Grass

Well-Known Member
Rollitup Advertiser
Yup still taking my clones in flower. I try for week 2, usually hit three and occasionally go a tad later. I'll check the date when I get upstairs later.

Also add water until it touches the base of your sprayer bars. Your pump is heating your water up too much. More water will act as a temp buffer. However I'd still add KLN
So I have my water too low. I currently have it just cover the pump, a couple inches from the bottom of the sprayer bars. I couldn't find any KLN at any of my local stores so I ordered from Amazon. The March 11-23 delivery kinda sucks. When I get this do I stop using clone x?

My PH meter went south on me. I'm not sure how long it's been bad.

I went to calibrate it on Friday and it read 4.8 in the 4.0 solution. I hit the calibrate button and it said it was calibrating to 4.0 but went back to 4.8 once it was done the calibration.

Brand new freshly calibrated meter reading 5.3

IMG_0042.JPG

Old bad meter reading 6.6... I would have adjusted it down based on that reading. :wall:
IMG_0043.JPG
 

curious2garden

Well-Known Mod
Staff member
So I have my water too low. I currently have it just cover the pump, a couple inches from the bottom of the sprayer bars. I couldn't find any KLN at any of my local stores so I ordered from Amazon. The March 11-23 delivery kinda sucks. When I get this do I stop using clone x?

My PH meter went south on me. I'm not sure how long it's been bad.

I went to calibrate it on Friday and it read 4.8 in the 4.0 solution. I hit the calibrate button and it said it was calibrating to 4.0 but went back to 4.8 once it was done the calibration.

Brand new freshly calibrated meter reading 5.3

View attachment 4840579

Old bad meter reading 6.6... I would have adjusted it down based on that reading. :wall:
View attachment 4840580
Have you tried changing the batteries in that old/bad meter? I've had to do mine a couple times in the time I've had it. I only use chlorinated water and KLN in my cloner.
 

Laughing Grass

Well-Known Member
Rollitup Advertiser
Have you tried changing the batteries in that old/bad meter? I've had to do mine a couple times in the time I've had it. I only use chlorinated water and KLN in my cloner.
I tried replacing the batteries, it didn't make much of a difference. When I swished it around it the water It swings wildly all over the place before it settles. The new one doesn't do that.

I'm kinda kicking myself in the ass. I bought that fancy apera bluetooth logging meter and two weeks ago the probe started giving me errors. The only replacement I could find was in the US and cost $130 US plus shipping/duties so I bought a bluelab pen for $120 CAD delivered. Two weeks later my PH pen goes, another $120. I could have bought the combo kit and saved $70 if they died at the same time. :cuss:


I've been using chlorinated water since I took the second set of clones.
 

curious2garden

Well-Known Mod
Staff member
I tried replacing the batteries, it didn't make much of a difference. When I swished it around it the water It swings wildly all over the place before it settles. The new one doesn't do that.

I'm kinda kicking myself in the ass. I bought that fancy apera bluetooth logging meter and two weeks ago the probe started giving me errors. The only replacement I could find was in the US and cost $130 US plus shipping/duties so I bought a bluelab pen for $120 CAD delivered. Two weeks later my PH pen goes, another $120. I could have bought the combo kit and saved $70 if they died at the same time. :cuss:


I've been using chlorinated water since I took the second set of clones.
I thought you would have tried changing out batteries but it wouldn't be the first time my stoned mind overlooked something LOL so I asked.

Ouch I'm sorry about the logging meter. Then the multiple failure. That would really hurt. I love my Bluelab pen. I hope yours lasts longer this time
 

Laughing Grass

Well-Known Member
Rollitup Advertiser
I thought you would have tried changing out batteries but it wouldn't be the first time my stoned mind overlooked something LOL so I asked.

Ouch I'm sorry about the logging meter. Then the multiple failure. That would really hurt. I love my Bluelab pen. I hope yours lasts longer this time
You gotta ask. :D I bought the first bluelabs combo kit in Dec 2018. The ppm pen started acting weird last June. When I was looking at troubleshooting docs for the PH pen they said the it's good for about 18 months of daily use then it should be replaced.
 

Wastei

Well-Known Member
I tried replacing the batteries, it didn't make much of a difference. When I swished it around it the water It swings wildly all over the place before it settles. The new one doesn't do that.

I'm kinda kicking myself in the ass. I bought that fancy apera bluetooth logging meter and two weeks ago the probe started giving me errors. The only replacement I could find was in the US and cost $130 US plus shipping/duties so I bought a bluelab pen for $120 CAD delivered. Two weeks later my PH pen goes, another $120. I could have bought the combo kit and saved $70 if they died at the same time. :cuss:


I've been using chlorinated water since I took the second set of clones.
Sounds like you've had really bad luck with the pH pens. Do you use storage solution(KCl)?
 
Top