How should i set up my ventilation.

[MrNoobman]

I have a 6' inline rhino for the carbon filer and 2 other 4 inch intake fans. With 2 oscillating fans inside.

Currently have the carbon filter set normally with 2 4' intakes bringing in cool air from outside.

Oscillating fan sits above the canopy pointed towards the light to try cool and stop hot air and the other is just blowing air around the pot level.

Temps are still roughly 27c and I'm wondering if its the way I have ventilation set up.

Humidity is 45% and I'm using a 600w hps in a 4x4 with 4 plants.

Also not sure if I have my thermometer in the correct place. Atm I have the probe around canopy level and the unit above the light next to the filter.

Any help appreciated. Thank you

 

[JimmyJackCorn]

Sounds good to this noob. Maybe a sensor above and below the canopy? I've heard of humidity problems on the underside.

 

[Beehive]

Is this a tent or a room?

 

[MrNoobman]

Is this a tent or a room?

A tent

 

[MrNoobman]

Sounds good to this noob. Maybe a sensor above and below the canopy? I've heard of humidity problems on the underside.

Just heard a lot about if the temp goes over 26 I could get airy buds etc. Not sure lol

 

[MrNoobman]

Figured out the problem. The extraction wasn't full power because the filter on my carbon filter was blocked with what looks like perlite dust. Noob moment again. Thanks

 

[JimmyJackCorn]

Just heard a lot about if the temp goes over 26 I could get airy buds etc. Not sure lol

Might be a little on the high side, but that's within the average range. How it reacts would depend on the strain, I guess.