Panda Tent with PVC frame T5's Bag seed First Grow Op

509$Finest

Member
set up is simple got enough PVC pipe and knuckles to create a 4x5x7ft frame for my veg room i got 10x100ft of panda plastic (white/black 2 sided plastic) wrapped the bottom than the sides than draped the top has door way that can roll up out of the way. heat stay in the 80's with the light on 70's off so far so good first grow. i'll be adding a second set of t5's when i get more plants going, there will be a second room for bloom that is a 4x4x7ft booth that will be under a 400w-600w (not sure yet) hps set up vented with a selfmade carbon filter, teach a man to grow, or get on the internet and fiqure some shit out.
 

Attachments

  • P1080795.jpg
    P1080795.jpg
    47.3 KB · Views: 81
  • P1080791.jpg
    P1080791.jpg
    59.7 KB · Views: 88
  • P1080730.jpg
    P1080730.jpg
    33.9 KB · Views: 104
  • P1080697.jpg
    P1080697.jpg
    30.5 KB · Views: 105
  • P1080731.jpg
    P1080731.jpg
    37.8 KB · Views: 118
  • P1080696.jpg
    P1080696.jpg
    34.4 KB · Views: 125
  • P1080726.jpg
    P1080726.jpg
    53.3 KB · Views: 94
I tried to do that but I couldnt find any knuckles or 3 way splitters.

i couldnt find the three way knuckle i wanted only these three ways that were like 1/2" on two sides and a screw on part for a size smaller so i bought the smaller ends and connected the shorter side of my tent with the smaller pvc
 
I've been trying to setup almost the same thing, but I have one question. How did you attach the panda film to the actual frame?
 
I've been trying to setup almost the same thing, but I have one question. How did you attach the panda film to the actual frame?

i just folded the extra over the pvc and taped it with white duck tape, i have to add a new piece or two to adjust every few days
 
Alright, cause all I could think of doing, was putting a top and bottom on, like wrapping a present, then wrapping the plastic around the mid section to cover the rest.
 
Back
Top