daveroller
Well-Known Member
System:
Nutrients:
Planning to use Advanced Nutrients (AN) nutes:
Sensi-Grow A+B
Sensi-Bloom A+B
Big Bud
Overdrive
Voodoo Juice
B-52
Grow Room Details:
Built an ordinary cabinet which is about:
. 38" wide
. 19" deep and
. 72" high
with a top shelf on top of which I installed a ceiling fan. A 6" hole through the shelf allows air into the fan and the exhaust is blown through insulated ducting and out the side of the cabinet. Another 6" hole at the base of the cabinet on the right side will let fresh air in. I'll attach another piece of ducting to that intake hole to keep light out. I'll also duct the air coming out of the exhaust hole up into my attic.
The fan is a Panasonic FV-15VQ5 WhisperCeiling 150 CFM Ventilation Fan. Very quiet.
Sprouting the Seeds:
I'm sprouting 3 seeds inside of coconut coir plugs surrounded by hydroton pellets inside of net pots. Placed each seed into one of the plugs, just below the top surface. The net pots are hanging into holes cut into the lid of an opaque container of water. I'm aerating the water with my Micro-Pore air stone. Added 8 ml of AN Voodoo Juice to 2 gallons of pure water. Water level is about 1 cm above the bottom of the net pots. I plan to let the sprouts grow for one week. Then I'll move the pots into my DWC/aero system without disturbing their contents at all.
Seeds:
3 Barney's Farm feminized "LSD". I selected these because of their high THC and other cannibinoid levels. I use pot to relieve chronic nerve pain, so this stuff should do the trick!
Here are some photos that should clarify what I'm doing:
This is my cabinet. No doors yet. I'll be putting this inside of my closet after I get someone to help me to cut a hole in my ceiling and install ducting from the cabinet to the attic. So far, I only planted the seeds today and they're inside of their net pots in my sprouting container. After a week, I'll move the net pots to the holes in the top of my DWC system, shown under the sprouting container.
Here is the closet that I'll move the cabinet into. Need to remove the shelves first.
Here is my sprouting container. Just a Rubbermaid container that I covered with aluminum tape to keep out light. I cut holes in the lid to hang the pots into. The plastic tube going into the lid leads to a Micro-Pore air stone.
If anyone has questions or suggestions, feel free to post here!
--Dave
- Not sure what to call it, but it's going to be a combination of bubbleponics, DWC and aeroponics. Roots will dangle down into the water reservoir.
- Water will be aerated using an air pump and a Micro-Pore air stone.
- Plants will be grown in net baskets that will hang down into holes in the lid of an 18-gallon tote.
- Water will be pumped up to the net baskets intermittently and sprayed over the hydroton pellets to keep the roots moist, but also let them absorb oxygen from the air.
- Another small water pump in the reservoir will rest on the bottom sideways, to keep the water constantly circulating.
Nutrients:
Planning to use Advanced Nutrients (AN) nutes:
Sensi-Grow A+B
Sensi-Bloom A+B
Big Bud
Overdrive
Voodoo Juice
B-52
Grow Room Details:
Built an ordinary cabinet which is about:
. 38" wide
. 19" deep and
. 72" high
with a top shelf on top of which I installed a ceiling fan. A 6" hole through the shelf allows air into the fan and the exhaust is blown through insulated ducting and out the side of the cabinet. Another 6" hole at the base of the cabinet on the right side will let fresh air in. I'll attach another piece of ducting to that intake hole to keep light out. I'll also duct the air coming out of the exhaust hole up into my attic.
The fan is a Panasonic FV-15VQ5 WhisperCeiling 150 CFM Ventilation Fan. Very quiet.
Sprouting the Seeds:
I'm sprouting 3 seeds inside of coconut coir plugs surrounded by hydroton pellets inside of net pots. Placed each seed into one of the plugs, just below the top surface. The net pots are hanging into holes cut into the lid of an opaque container of water. I'm aerating the water with my Micro-Pore air stone. Added 8 ml of AN Voodoo Juice to 2 gallons of pure water. Water level is about 1 cm above the bottom of the net pots. I plan to let the sprouts grow for one week. Then I'll move the pots into my DWC/aero system without disturbing their contents at all.
Seeds:
3 Barney's Farm feminized "LSD". I selected these because of their high THC and other cannibinoid levels. I use pot to relieve chronic nerve pain, so this stuff should do the trick!
Here are some photos that should clarify what I'm doing:
This is my cabinet. No doors yet. I'll be putting this inside of my closet after I get someone to help me to cut a hole in my ceiling and install ducting from the cabinet to the attic. So far, I only planted the seeds today and they're inside of their net pots in my sprouting container. After a week, I'll move the net pots to the holes in the top of my DWC system, shown under the sprouting container.
Here is the closet that I'll move the cabinet into. Need to remove the shelves first.
Here is my sprouting container. Just a Rubbermaid container that I covered with aluminum tape to keep out light. I cut holes in the lid to hang the pots into. The plastic tube going into the lid leads to a Micro-Pore air stone.
If anyone has questions or suggestions, feel free to post here!
--Dave