o'brother
Member
I am running a nute film system. A 2o gal tank with 4 trays on each side. In each tray are 5 plants in rock wool cubes. The nutes are fed through a hose in one end, and feed the plants as it runs to the other end and drains back in the tank. At this point I am two weeks into flower. I am useing general hydroponics plus calmag,floralicious,and super thrive. Also I am cranking co2 with a genator and titan atlas monitor. Last week after changing nutes, within a couple days the ph started rising daily. It would drop as much as a point in 24 hrs. I adjusted this daily for 6 or 7 days. I did notice some rust spots on the oldest fan leaves of one strain of plants, But only on a few.Tonight I was going to change nutes.When I went in I saw a number of plants had a little wilt. I decided before adding new nutes,I would flush with Super Natural flush. It's for flushing built up salts. In the process of all this I found one of the pumps had clogged. the plants were ok because their roots had run down the drain into the tank and were providing enough nutesto survive.Probably could do better with proper circulation. so, Now I have the flush circulating. I'm thinking of letting it circulate for 24 hrs before putting the nutes back in. Is anybody able to comment on this situation and advise me about the flush or anything else for that matter. This is my first hydro grow and I welcome any input. thanks. As an after thought should I shut off the co2 durring the flush?