I gave it them for just a few watering but that was a few week ago the calmag I have has nitrogen in as well should i just put in the recommended full dosage and then just add the a and b until desired ec
So over the past 2 days my plants have started to get rusty spots on them they are in coco I watered them with a ph of 5.9 and an ec of 1.4 feeding them canna coco a and b rhizo and zym and I also gave them 0.5 ml a liter of silicone my temperature hasn't gone ove 85f and the past 2 days it's...
I've not grown for quite a few years now but I used to use a tiny bit after the formation of flowers properly started and then near the end I used to always use cannas light feeding chart and then use just under their recommendation but I now have an ec meter and I was surprised at how strong it...
Thanks for the input I've got these things called blumat drippers that water based on the moisture level so they constantly get feed and water when needed I was planning on hand watering every 3 days to get run off do you think with this kind of setup I should feed at half the normal strength...
So I found this image online showing the different ec readings for different plant stages here is the text from the site I spotted it on
An indicative EC range for cannabis plants is 0.8-1.3 for seedlings; 0.5-1.3 for clones; 1.3-1.7 under vegetative phase; 1.2-2 during flowering. Different...
So I've just purchased a 3 part filter it has hose quick connects on each side on the output side can I just connect a hose to it or do I need to use the 1/4 inch reducer or is that only to get more pressure or can it effect performance or is that size only needed for a proper ro filter
So I have some peyote and Peruvian torch I'm in the UK if I keep them relatively warm and on a window ledge will they both grow fine but at a drastically lower rate or would they eventually die also the peyote is already rooted but not the Peruvian torch I've just put that in pot with 3 perlite...