I’m using about the same water as you. I run 600ppm well water through an ro then uv to a stainless storage tank. Have always had root issues. I don’t think there are any ferts that don’t react with chlorine. I am using pool shock atm. It does seem to work. Even though it shows 0ppm after...
Is your pump in a bucket? You will need to run the hose in the side of the bucket. Or raise your trays. Water dosent run up hill and your pump is most likely not positive displacement. Meaning it needs water in it to pump.
I’ve had issues with VBB, Hawaiian cat piss and TKNL5haze f2 or 3 can’t remember off hand. I notified him. May get them replaced.
I’ve popped over 100seeds this winter and no issues with others. They seem to crack and want to grow but just peter out. I’m guessing age.
nice thing is the only 2...
MTF commimg along nicely. Think I have 7 on the go. All look real nice. Wish the boys would show. But most of my veg plants are holding out.
907 Bluegenes, same for these. No one is showing sex, some have been flipped, that should help.
Recirc works fine with coco. I used it in a greenhouse one season. 3 plants 20 gallon res. Dumped res when it got down to 3 gallons and refreshed with nutes/water. Nothing fancy either 3gallon pots. 40deg days, middle plant made a lb. Best way maybe not. But doable.
They are about 10"tall. I'll get some picks up later. I have
vintage blueberry flowering. Didn't have very good germination 2 girls 3 boys.
Chocolope good germination. 5 girls 4 boys flowering.
MTF good germination about 10"
Tknl5haze F2 very poor germination 0-full pack. Had a few crack then...
I cut 1x1x2" blocks to clone in or start seeds in. These are the ones I spin out. Then add back a mill or 2. I use a bit of peroxide in the soak. The cubes are way too wet for cloning in after soaking, after the spin they are about right. Nice and light. Spinner is not big enough for a big cube.
Just a tip on RW. Im not a RW grower per say but do some cloning and seed starting in RW. Soak in your prefered ph balancing liquid with whatever additives you use, then into the salad spinner. You can remove almost all the water without distorting the cube.
A vacuume break is basically a small leak downstream of the pump back to the rest. Usually just a small T in the discharge hose. When the pump shuts off it allows air in preventing siphoning.