1st grow tell me how I'm doing

J2324D

New Member
This is my first grow it's a bag seed it's in a 5 gallon bucket with ffof with about 40 percent perlite its about 3 weeks old about 250 watts of cfls been watering it every 3 to 4 days haven't used any nutes I think that's about it let me know what u think and what could be done betterimage.jpgimage.jpg image.jpg image.jpg
 

screediu

Well-Known Member
what are your temps they look a little heat stressed. also i would mix a little bit of cal/mag into your next watering unless your using tap then just a little bit of epsom salt 1 teaspoon per gallon should do it good
 

TheTrippyHippie

Well-Known Member
I wouldn't remove any foliage this early into it. It's common to get a little burn or minor deficiencies in its early stages, especially with Fox Farm (what I use as well). Adding a little lime helped fix a lot of the problems during early growth.
 

J2324D

New Member
My temps are about 84 to 80 I have two fans blowing in the closet and my house thermostat is set at 72 I don't know what else to do short of cutting in an air duct vent straight into the closet and thanks I ll hold off on cutting anything off
 
I was a little worried when I saw the nute burn/heat stress but it looks like you've been doing a good job in the second pics!

Don't cut any leaves unless they're more than 50% damaged, and if that happens in veg you have serious problems anyway.

Bitch please, I've grown at 110+ before.
 

flynfish

Member
0708140559.jpg heres my first grow at 4 weeks with just a little fish emulsion starting at 3rd week. starting morbloom 0-10-10 today. at 1/4 strength. let me know what yall think
 

BenFranklin

Well-Known Member
OK, it goes like this.... DO NOT PRUNE LOWER LEAVES, those lower leaves provide, light, nutes, sugars, respiration and energy to the very growth that you want to make "larger", the new growth won't grow new that quickly, by removing the very thing that they depend on to make them grow to begin with.

The best rule of thumb is to leave them alone.
 

flynfish

Member
I will be im using Alaska morbloom 0-10-10 along with a little fish emulsion its 5-1-1. will be going full strength on both on the 10th. other than that hope she looks good. green is good
 

flynfish

Member
im using the Alaska fish emulsion 5-1-1 and morbloom 0-10-10 with ffof and am having good result. is my first grw and thx guys I will leave the lower leaves alone.
 
Top