$275 DIY Rosin Plates, PID Controller, and Press

CannaBruh

CannaBruh

Well-Known Member
Greengenes707 said:
Ya, youtube deleted me at 40K subs and over 500,000 views on that video. No oone is really sure why other than being bigits and puppets to their advertisers and being overly cautious with "community guidelines.
Working on getting the video back up, but need to make sure I am in the OK first and havent got a clear answer on that yet.
Click to expand...
#1 bullshit Gene, hope you get it back online.
 
C

ColoradoRob

New Member
There are a lot of places to post the video brother. I bought all the stuff 3 days before they took it down and still looking to complete before my legal grow is complete lol.
Dailymotion
Break
Hell I can even host it for you (IT Director) to where no one can touch it.
YouTube is a joke
 
Farmer.J

Farmer.J

Well-Known Member
Airwalker16 said:
Relay doesn't need a heatsink turns out. Lemme know I'd you need help with the PID. Its easy
Click to expand...
Thanks, I have a Lazer thermometer and it's saying the thermocouple reading is higher than actual.

I didn't know it didn't need a heat sink but I ordered it and it fits in the project box so I put it in anyway. I had to buy a small roll of 16 gauge wire, I just used white for everything.
The plates, heaters, pid, relay, heatsink, cords, project box, drill bits, 16 gauge wire, 10 ton press and wago connectors cost me about $530 (Canadian) total. Everything from amazon except for the press and 16 gauge wire (princess Auto)
 
Last edited:
Airwalker16

Airwalker16

Well-Known Member
Farmer.J said:
Thanks, I have a Lazer thermometer and it's saying the thermocouple reading is higher than actual.

I didn't know it didn't need a heat sink but I ordered it and it fits in the project box so I put it in anyway. I had to buy a small roll of 16 gauge wire, I just used white for everything.
The plates, heaters, pid, relay, heatsink, cords, project box, drill bits, 16 gauge wire, 10 ton press and wago connectors cost me about $530 (Canadian) total. Everything from amazon except for the press and 16 gauge wire (princess Auto)
Click to expand...
Hm... Mine was less than$150USD
 
J

Jay-420

New Member
i cant find the heating element in stock can i use a 8mmx80mm 110v 250w cartridge or should i find the other one's that are listed?
 
Farmer.J

Farmer.J

Well-Known Member
Go go n chill said:
Do you think the heat plate kits going around now would work better? I found hydraulic presses on Jeg’s website 6 ton for$107 free shipping
Click to expand...
I don't know, if I was going to do it all over I would have a pid for each plate, and a larger project box. I would install both pid's to the lid of the project box. The heatsink and relay would mount inside the project box. This would make it easier to wire.
 
You must log in or register to reply here.
Top