510 thread dry herb tanks

[esh dov ets]

so butane will blend fully? what pg/vg ratio would you say the consistency of this led quid is?

the peg is heavier clouds and thinner depending on the # after it 200-400 are optimal.

 

[esh dov ets]

theres no vg or pg in it at all.....its all peg-200 and peg-400....which is what people vaped-harmlessly-before morons pointed out that these are components in some antifreeze...and you can't drink antifreeze......of course, you aren't drinking it.....

and i don't use bho, i don't like the thought of it, i was speaking more from a consistency viewpoint, but i'm sure you would have no problem getting bho to dissolve in the peg mix.
you can either use a hot water bath or just put your container in the microwave about 8 seconds, stir vigorously, if it does't all dissolve, give it about another 5 and stir till it does, it takes quite a long time to settle out, and just a good shake or two gets it mixed back up.
i'm thinking about getting an emulsion blender, pretty sure if you hit it with one of those fresh out of the microwave it would never seperate at all

the consistency of the peg is quite thin, but the concentrate you add to it thickens it up quite a bit. wax-liquidizer says 2 ml to a gram of concentrate, but i've found three works a little better, may not be quite as potent, but it also doesn't gum up my coil in a couple of days

Ethylene glycol is poison and in anti freeze,. it's the same kind of misinformation when people say drugs are made with drain cleaner. some people are allergic to the synthetic chemicals such as pg and peg. one gives me a headache and i don't like either from experience where as the vg doesn't hit as good. i'm curious what is in heavy hitters brand or bloom brand cartiges. i know bloom boasts that it's all natural and they both hit good and taste good esp compared to a few others like alpine cartridges or bloom farms .

 

[Roger A. Shrubber]

yeah, but i tried like hell to get stuff to dissolve in vg...doesn't work worth a shit, heated it, stirred it, agitated it..did everything but give it a hand job.....what did seem to dissolve settled out over night.
had slightly better results with propylene glycol, but still not even half as good as with the peg mix

 

[twostrokenut]

yeah, but i tried like hell to get stuff to dissolve in vg...doesn't work worth a shit, heated it, stirred it, agitated it..did everything but give it a hand job.....what did seem to dissolve settled out over night.
had slightly better results with propylene glycol, but still not even half as good as with the peg mix

so what setup are you using to vape the peg mix? should I just drip it onto some .2ohm dual alien claptons in the old kennedy at 80w or?