420newbieg
Well-Known Member
I have done a few runs most of the time I have gotten taffy which I have made with a guy from kush weed trim yield was not great even with candy kush trim it seemed.
Anyways I recently harvested some candy chem stuff seemed loaded with crystals however when I blasted some the yield was rather low I used a half of smaller bud atleast that I had on a couple branches sitting around for 3-4 days I plucked them all off the stems and froze them id maybe an eighth at most was trim and if u account for the fact that I left the small leaf on those buds.
I have only tried this a few times maybe closer to 10 batches but I mostly used just trim.
I froze the stuff for about an hour and a half the gas too packed the tube till it had about an inch or 2 left of room had a trusty 10 oz can of special blue 9x ran it threw outside of course everything looked so clear the whole time I could not really tell at that point if I ran enough gas threw the material good so I got the warm water poured it in the bottom pan you know the typical process only came out with 2.4 g maybe of oil.
Idk if the nugs were still to fresh and all the damp weather I see guys mentioning 7g return rate with trim being less som I'm just trying to figure out if I should be getting another can and trying to reblast for the rest .
Anyways I recently harvested some candy chem stuff seemed loaded with crystals however when I blasted some the yield was rather low I used a half of smaller bud atleast that I had on a couple branches sitting around for 3-4 days I plucked them all off the stems and froze them id maybe an eighth at most was trim and if u account for the fact that I left the small leaf on those buds.
I have only tried this a few times maybe closer to 10 batches but I mostly used just trim.
I froze the stuff for about an hour and a half the gas too packed the tube till it had about an inch or 2 left of room had a trusty 10 oz can of special blue 9x ran it threw outside of course everything looked so clear the whole time I could not really tell at that point if I ran enough gas threw the material good so I got the warm water poured it in the bottom pan you know the typical process only came out with 2.4 g maybe of oil.
Idk if the nugs were still to fresh and all the damp weather I see guys mentioning 7g return rate with trim being less som I'm just trying to figure out if I should be getting another can and trying to reblast for the rest .