.
sounds like it came out perfectly!
it's not quite dry yet but it's much more than I though, there's a bit on the parchment paper still too, so I think there will be at least 1.8ish which is killer! I'll update with the fully dry weight tomorrow 
Dude your suppose to put the 190 in the 45. So the material goes through the 190 first. The 190 will strain all the plant matter and junk allowing only water (full of trichomes) through and to the 45 bag. The 45 will allow only water through leaving you with some mud looking stuff on the screen. That's it
If your material is still in the 45 bag, put it back in the bucket with the same water, mix and set aside. Clean your 45 bag making sure no debris is left in it. Put the 190 bag IN the 45 and pour the material/water in the 190 bag.
Do what drcanna mentioned, rinse everything back into a bucket with using the same water and plant material. Then on another bucket but the 45u bag on first, then the 190u on TOP of the 45u and pour the water/trim into the 190u. Lift the 190u bag, squeeze the trim gently to get most of the water out. Clean the bag and set aside. Then lift the 45u bag up and your hash will be in the bottom. I set the bag over an upside down bowl so the screen sets on top of the bowl making it easier to collect the resin. I use the sprayer from the sink to spray gently the bag to collect all the hash from the sides of the bag and collect them to the middle of the screen, then I scoop it up with a spoon. Good luck man, sorry you had a bad experience :/ It must be in the air with my jar exploding
Hmm, that is weird! Was the trim completely submerged under water? Did you use sugar leaves/ popcorn buds? No fan leaves or anything like that that doesn't have trichomes on it?
Well it worked, sort of. I got a very small amount that is drying now. Still it was a relief to see something in the bag