• Here is a link to the full explanation: https://rollitup.org/t/welcome-back-did-you-try-turning-it-off-and-on-again.1104810/

Cutter Electronics: Complete DIY COB kits

welight

welight

Well-Known Member
just crowbarred these out from under 15000 shipping containers

1000 in stock, now all fully drilled and tapped on every hole so will suit Ideals for CXB3590/3070 and all Zhaga compliant holders or COBS with Zhaga footprint built in connectors like Vero or holes. Backorder shipping begins......
Cheers
Mark
 
welight

welight

Well-Known Member
OLD MOTHER SATIVA said:
CXB3070 BB 3500k 164.51 LPW 49.83W


i like the passive idea but dunno about the cost ..delivery to canada?


4.perhaps i should remove this because it is in Cutters thread..sorry about that?

maybe i should get Cutter heatsinks ..to make up for this
Click to expand...
you totally should...:)
Cheers
Mark
 
OLD MOTHER SATIVA

OLD MOTHER SATIVA

Well-Known Member
"maybe i should get Cutter heatsinks" ..to make up for this

>thanks..i totally will...[as well as delete the post]

..i just cannot afford 30 @3590's for these discount meanwells..so that was why ilooked at the citzens..ifngtheyever stock em again..
 
BOBBY_G

BOBBY_G

Well-Known Member
hey mark i know youre slammed with back orders but can you check your email, id like to get an order in today if possible
 
Humble grower

Humble grower

Well-Known Member
Hey everyone I have a quick question I ordered the 1-10v dimmer from cutter with my kits and wanted to make sure that these will work with these drivers and if I can hook both drivers (I ordered 2 of the 4 cobb kits) to 1 dimmer so all 8 Cobbs dim equally. I know the yellow wire is a 10 volt power and I think the purple wire is the positive and grey is the negative so I wanted to make sure before I hooked em up that I am supposed to cap the yellow and run the purple to the positive and gray to the negative. Thanks in advance and I'll post some pics after I finish building it this weekend
 
welight

welight

Well-Known Member
Humble grower said:
Hey everyone I have a quick question I ordered the 1-10v dimmer from cutter with my kits and wanted to make sure that these will work with these drivers and if I can hook both drivers (I ordered 2 of the 4 cobb kits) to 1 dimmer so all 8 Cobbs dim equally. I know the yellow wire is a 10 volt power and I think the purple wire is the positive and grey is the negative so I wanted to make sure before I hooked em up that I am supposed to cap the yellow and run the purple to the positive and gray to the negative. Thanks in advance and I'll post some pics after I finish building it this weekend
Click to expand...
Hi Humble
Which kit did you order?
Cheers
Mark
 
L

LordRalh3

Well-Known Member
when your looking for the stuff don't do 12 inch tiny pieces, do a longer bar that can span the entire middle of the standard 3 or 4 foot area
 
You must log in or register to reply here.
Top