diy aero cloner pump size ?

countryboystoner

Active Member
Hi I have plans on building a diy aero cloner. 8 or 10 site cloner out a five gallon bucket my question is what size pump do I need for this type set up ? I see factory made bucket cloners using pumps anywhere form 165GPH to 265GPH pumps my ? Is. Whould either of these work well with this type set up and which size would be better
 
You can't have two much spray, unless its blowing your plumbing apart. However, I have never seen a pump that strong. The pvc pipe in the picture is NOT glued. It comes apart for easy cleaning and it has never fallen apart. I would always opt for the bigger pump.
 

Attachments

  • IMG_2569.JPG
    IMG_2569.JPG
    526.2 KB · Views: 91
  • IMG_2570.JPG
    IMG_2570.JPG
    492.2 KB · Views: 89
You can't have two much spray, unless its blowing your plumbing apart. However, I have never seen a pump that strong. The pvc pipe in the picture is NOT glued. It comes apart for easy cleaning and it has never fallen apart. I would always opt for the bigger pump.
How'd you cut the holes? When I do it I tend to have a very hard time getting a clean cut. It's always rough and either to tight or loose for the neoprene holders.
 
Side note the smaller the cloner and the bigger the pump the warmer the water which isn't good. I've had problems in my 5 gallons bc of heat the pump gives off into the water
 
How'd you cut the holes? When I do it I tend to have a very hard time getting a clean cut. It's always rough and either to tight or loose for the neoprene holders.
2" hole saw.......
Side note the smaller the cloner and the bigger the pump the warmer the water which isn't good. I've had problems in my 5 gallons bc of heat the pump gives off into the water
I have problems to with heat so I run my cloner wit ha fix cycle timer that's 1/4. One minute on and 4 minutes off with frozen bottles. This is I think 15 days in the cloner.
 
How'd you cut the holes? When I do it I tend to have a very hard time getting a clean cut. It's always rough and either to tight or loose for the neoprene holders.
Regular drill wit a door nob cutter. Those holes are a little they are not as smooth as the picture looks, The black foam hides the sins:)
Side note the smaller the cloner and the bigger the pump the warmer the water which isn't good. I've had problems in my 5 gallons bc of heat the pump gives off into the water
Steezy Wonder up there said" he could buy a cloner for $80" That's the way I would go. When these were built, cloners were $300+ If I did not have these, I would buy one.
 
2" hole saw.......

I have problems to with heat so I run my cloner wit ha fix cycle timer that's 1/4. One minute on and 4 minutes off with frozen bottles. This is I think 15 days in the cloner.
I like that idea. I thought about it but wasn't sure exactly if it would for sure work.
 
Back
Top