Friskjuice
Member
I was bored at work, and came up with this idea of how to make my own ventilation tube. Disclaimer: I have not actually tried this, just putting the idea out there. Please share what you think will work equal or even better as materials to this concept here!
If you dont get the idea yet, the main idea is to make the skeleton of the tube with the chicken wire, which is connected together with the strips. The plastic is then wrapped around, and sealed properly with duct tape (to make sure of no air escape, even silicone, soft glue etc. etc. can be added here, please give feedback). Use a thick rope or similar to mount the finished tube to the ceiling every 1-2 meters or so.
Hope this got some ideas spinning out there, i bet there are several better ways to improve this idea of cost effeciency and quality (airflow etc.)
If you dont get the idea yet, the main idea is to make the skeleton of the tube with the chicken wire, which is connected together with the strips. The plastic is then wrapped around, and sealed properly with duct tape (to make sure of no air escape, even silicone, soft glue etc. etc. can be added here, please give feedback). Use a thick rope or similar to mount the finished tube to the ceiling every 1-2 meters or so.
Hope this got some ideas spinning out there, i bet there are several better ways to improve this idea of cost effeciency and quality (airflow etc.)
