doublejj's next big adventure....Lone Oak Farms 2016
- Thread starter doublejj
- Start date
ruby fruit
Well-Known Member
It gives me the same satisfying feeling as dropping a fart in a shoping aisle and watching some sexy chick walk into it
I can and don't even have to listen to him cry .You know you like to go over, call uncle fuck a fuck and haul ass
doublejj
Well-Known Member
I think I figured out why these have problems. They are pneumatic and have a max pressure of #2000 lbs. It takes more pressure to get a good squish, so people are maxing this unit each press & soon the seals fail.
Vnsmkr
Well-Known Member
Yip misuse I would say. I know they are a grand more but those sasquash presses have been reinforced and they tell you to limit your air pressure to max 85 psi.......
Air operated hydraulic
These hydraulics are welded to prevent leaks from happening. They are quite and operate very
smooth, also short to reduce size and weight of entire unit.
Welded release handle
20 Ton
Operating air pressure: 70-85psi, DO NOT EXCEED 85psi.
• Upper platen assembly
Welded to hydraulic, has hoops for lifting springs and plate for attaching upper platen. Two large
pipes fully welded for even spread of pressure, and to prevent heat traveling to hydraulic and frame
Air operated hydraulic
These hydraulics are welded to prevent leaks from happening. They are quite and operate very
smooth, also short to reduce size and weight of entire unit.
Welded release handle
20 Ton
Operating air pressure: 70-85psi, DO NOT EXCEED 85psi.
• Upper platen assembly
Welded to hydraulic, has hoops for lifting springs and plate for attaching upper platen. Two large
pipes fully welded for even spread of pressure, and to prevent heat traveling to hydraulic and frame
doublejj
Well-Known Member
I'm looking at a 20 ton Harbor freight shop press & some added heated plates..$199
http://www.harborfreight.com/20-ton-shop-press-32879.html
http://www.harborfreight.com/20-ton-shop-press-32879.html
Larry {the} Gardener
Well-Known Member
I spend a little time on tractorbynet, and there is a thread on there called "Harbor Freight tools that don't suck." You may have to add yours once you get it rigged.
Vnsmkr
Well-Known Member
Alot of people have gone this route I think.....Heres a thread I just found, quite long....https://www.rollitup.org/t/rosin-tech.869445/page-36#post-12314217
Olive Drab Green
Well-Known Member
He didn't get T-boned, he drove into it because the autopilot didn't contrast the trailer against the sky and it saw the trailer as part of the sky.