Help Figure Positioning 4x8

Hey guys have a GL120L and have a bit of a problem, I cant seem to piece together.

I have a 6" magnum xxxl and a 8" blockbuster

I also have 2 8" fans and 2 6" fan I can use for this setup. My filter is a 8x24 phat filter, I also have a 6x24 I could use in replace but the rated cfm is lower than my 8" fan so that wont work.

I was planning one 8" fan be dedicated to the filter mounted inside the tent but I cant seem to figure how to make it work ducting the lights with 2 different sized hoods. Could I run the filter before the blockbuster and out the top, then just a 6" fan to cool the magnum.

Sorry if this is hard to read or understand would love if anyone could help!

PS I do not want to run the filter before the lights I want 2 different duct setup. Also both will be Y ducted out the cieling.

Is it not recommended I thought to run the 8" Filter >> 8" Light >reducer> 6" Light >> 6" fan?
I would love to run 8" filter >> 8" fan to cool the room
then Im stuck how to cool my lights with 2 different sized hoods. I have both 8" and 6" fans so let me hear your combinations

ChemWreck said:

Is it not recommended I thought to run the 8" Filter >> 8" Light >reducer> 6" Light >> 6" fan?
I would love to run 8" filter >> 8" fan to cool the room
then Im stuck how to cool my lights with 2 different sized hoods. I have both 8" and 6" fans so let me hear your combinations

Click to expand...

filter->8inch hood->reducer->6inch hood->6in fan

i have the same tent. i used to have xxxl hoods but swapped them out because 2 of them would not fit in there. not sure how it would wirk with 1 blockbuster but measure it out first cause it sounds like it's gonna be a tight fit.

i would get a duct reducer like suggested above but i would run the 6" hood first and then the 8" hood and fan. then just dedicate the filter to exhaust back into the room.

shit im sorry i was so high when i wrote that i mean in the reverse order:
filter<-8inch hood<-reducer<-6inch hood<-6in fan