rekoj0916
Well-Known Member
Finally in a position that will allow for ample expansion. Currently using a tent with a 1k in there. Any constructive criticism/assistance is greatly appreciated as there must be numerous things I haven't accounted for. Hoping to build up to the following:
2 sealed bloom rooms to allow for CO2 enrichment
-not sure if tanks or burners as I've never added CO2, leaning towards tanks.
-dehumidifiers will be introduced as necessary
-not sure what size a/c yet
8 – 1000w lights an Air Cooled Hoods, 4 in each bloom room
-Powered by 4 solis-tek matrix ballasts w/flip box all connected to a Titan 8 light controller w/dual trigger cords. I only need a 4 light controller but figured I'd pay an extra $50 for double the outlets to allow for future expansion.
Two 4 plant RDWC systems/room so a total of 8 plants/bloom room.
I was thinking of putting reservoirs outside of the bloom room by running the piping through the wall and sealing it around the hole. Or should I put them inside the bloom room?
What size fan should I use to vent the heat from 4 hoods?
Should I vent out of the roof (in garage)?
Since you don't run CO2 the last couple weeks of flower (I've been told) once its shut off how do you exchange air?
Should I have an exhaust system in place for the last two weeks in each room?
Suggestions on room sizes?
This room will most likely be located in the garage. I'm thinking of essentially having half sealed off with a separate entrance and using this space for the rooms. If not obvious already, I've never designed anything of this nature or even remotely close. Therefore feedback is highly appreciated and encouraged as well as any questions that may provide useful insight.
2 sealed bloom rooms to allow for CO2 enrichment
-not sure if tanks or burners as I've never added CO2, leaning towards tanks.
-dehumidifiers will be introduced as necessary
-not sure what size a/c yet
8 – 1000w lights an Air Cooled Hoods, 4 in each bloom room
-Powered by 4 solis-tek matrix ballasts w/flip box all connected to a Titan 8 light controller w/dual trigger cords. I only need a 4 light controller but figured I'd pay an extra $50 for double the outlets to allow for future expansion.
Two 4 plant RDWC systems/room so a total of 8 plants/bloom room.
I was thinking of putting reservoirs outside of the bloom room by running the piping through the wall and sealing it around the hole. Or should I put them inside the bloom room?
What size fan should I use to vent the heat from 4 hoods?
Should I vent out of the roof (in garage)?
Since you don't run CO2 the last couple weeks of flower (I've been told) once its shut off how do you exchange air?
Should I have an exhaust system in place for the last two weeks in each room?
Suggestions on room sizes?
This room will most likely be located in the garage. I'm thinking of essentially having half sealed off with a separate entrance and using this space for the rooms. If not obvious already, I've never designed anything of this nature or even remotely close. Therefore feedback is highly appreciated and encouraged as well as any questions that may provide useful insight.