Help with cutting holes.
- Thread starter kngblnk
- Start date
racerboy71
bud bootlegger
i'm not trying to be evil here, but aren't most net posts sold in say, a two inch size, or a four inch size, etc, etc, etc?
faller200
Well-Known Member
Try one of these gizmos ^
Exactly what I was going to suggest. It's one thing to lack knowledge but why would a person want to prove that point to the world???
farmasensist
Well-Known Member
I use 2"net pots and a 2" hole saw. They don't fall through. The lip is a little wider than 2"
Ilovebush
Well-Known Member
You can use one of these if spending 5.50 isn't an issue...
http://goo.gl/oBhGWG
or you can build one of your own, using wood, around the net pot of your choice to get the exact measurement. To build it, simply use 3 wooden paint mixing sticks layed out in the shape of a C around the net pot. Next, you can fasten the sticks using glue or screws, remove the net pot and measure your diameter.
http://goo.gl/oBhGWG
or you can build one of your own, using wood, around the net pot of your choice to get the exact measurement. To build it, simply use 3 wooden paint mixing sticks layed out in the shape of a C around the net pot. Next, you can fasten the sticks using glue or screws, remove the net pot and measure your diameter.
superstoner1
Well-Known Member
I use a hole saw that is 1/8" smaller than netpot so it is secured when pushed in. There are 3-4 manufacturers of netpots but the hydrofarm are the best with the biggest lip and you can get 200 2" for $20
jdizzle84
Member
I do the same thing then line the rim with split air line tubing and its perfect