Hermi Horrors needs a HERO!!!??

So to night I just notice some nanners on the bottom of my FIRE OG plant that has been flowering for 7 weeks. Mind you I have 5 others flowering as well with no signs of seeds and chopped one last week with no seeds as well.

I was starring at these yellow dongs thinking FUCK! I jump up grab a water filled squirt bottle and start plucking these man noodles off. Sprayed the nanners down with water. Start plucking about 10 of them off and realize they are only on the low, small and under develop buds that will be thrown in the trim pile. SO then I start trimming them off and throwing them in some water with 10% bleach....HOLY SHIT what am I doing?

Now grabbing the entire plant and take it into another room. I go back out and spray the entire grow tent down with bleach and water and mist everything inside the tent except the flowers growing and turn off the circulation fan. Shut the tent and spray down the entire area outside the tent.....back to the FIRE OG plant....

Needless to say I just finished trimming her, and she is hanging to dry now...... So now I have a few questions to pose...

Question 1:
Note the observation I made when trimming...I would say at the most there were about 30 sets of nanners but only on the lower part. Only on the side which is directly in front of the zipper to my tent. First I was thinking genetics but after the trim more like light leak. Logical?

Question 1a:
This really depends on the answer to good ole question 1. I have many clones of this plant going now would you chuck them or say screw it!!! and flower them anyways? My guess would be that if it is light leak to keep them, if genetic...feed them to the pigs! Irrational?

Question 2:
The rest of my plans are about 90% cloudy with no signs of seeds. What would you do with them?


Here is the poor lady a few weeks ago, RIP pretty girl Idiodic?

Its hard to say what caused it.
This could be roAdalization- over mature mature plants make Nanners as a survival strategy.
Since it's 9o% cloudy this sounds feasible.

Some plants have a tendency to hermi in the lower areas where the light is weekest.
Adding more Side light there will prevent this IMHO.
But check the zipper also.

I'd keep her going if only one showed balls.

Also be sure to clean Good or the pollen could show up later.

there were about 40 sets of nanners and I chopped her in haste last night. I am chopping the rest of my crop on Sunday and thinking about what to do with the clones of the same plant...hmmm

If you are not 110% confident that your setup was as good as it can get and you didn't have a chance of light leak or any other environmental issues, then grow another round. Take extreme caution and make sure your setup is dialed in! I, as well as others have messed up in a grow and caused too much stress to plants which forced them to produce some seeds. It is part of the learning experience of "what not to do" as you are getting the hang of it! Really good breeders actually do this on purpose to find the heartiest plants of a strain to use for breeding purposes! This is why it is a good idea to research breeders extensively prior to making a purchase of seeds.(make sure you are getting top notch quality in every way)

i took clones from a plant that hermied and flowered em. they turned out fine. but clean up all polin. also i let hermie finish (in different space) and it didnt even end up with seeds. now as for balls? or nanners? nanners like said in a previous post could be them being over ripened.

yeah they were nanaers ans i dont think it was from over ripened...I am going to check a few things and let the clones go one more round.

Question one: Most likely genetics as the others plants are fine
Question two: Do an emergency flush. Chop it get it out of there and put it on a bucket filled with water.. This will trick the plant to think she's still alive and will finish your buds. Don't let that plant seed the others man!