Hlg-600h wire question
- Thread starter s0me0ne
- Start date
Airwalker16
Well-Known Member
That's I'm not so sure on...... @CobKits do you have to connect both pairs of Pos and Neg wires to your parallel setup to get full output or can you just use one pair?
ye wanted to ask that can i connect in parallel? and what type of remote control?
Airwalker16
Well-Known Member
You've got to do parallel with that driver. It's CV not CC. Only the drivers with a C in them can be used for series.
I.e. HLG-###H-"C"####A/B
no i meant like both - - and ++ wire to the - + of the led setup
nevergoodenuf
Well-Known Member
I would use both, that is a lot of current for one line. I have always used both.
Never heard that before. I believe both output cables connect to the same points internally, they simply use two 14g output cables rather than one heavy 10g or 12g cable.
It should be fine to parallel the two output cables.
pulpoinspace
Well-Known Member
^^Yep. 14awg isn’t rated for the amount of current if you ran the full load off one set of leads that’s why there are two. Use both.
Ignore rc unless you wanna add a switch.
Ignore rc unless you wanna add a switch.
Similar threads
