Milky Weed
Well-Known Member
I do not have the answer, I wanted to make a thread on solutions. The best way to avoid this is to set up a well draining media so it is harder to over water.
But what if you have your stuff set up, and realize it may not work so well with the way you water? I have seen a few suggestions.
Im in a situation where my specific media does not preform well until the roots fill out the pot. It is also drain to waste hydro, so this is an issue because I fully saturate to run-off.
I have successfully stuck shis-kebabs into the soil to oxygenate it, poking many holes. It also helped to squish the pot and roll the media around, sucking some air into it I believe.
What would you do in this situation? My media is basically all peat and holds a ridiculous amount of water. Usually I just wait until the roots fill out and then droopy leaf’s stop.
But what if you have your stuff set up, and realize it may not work so well with the way you water? I have seen a few suggestions.
Im in a situation where my specific media does not preform well until the roots fill out the pot. It is also drain to waste hydro, so this is an issue because I fully saturate to run-off.
I have successfully stuck shis-kebabs into the soil to oxygenate it, poking many holes. It also helped to squish the pot and roll the media around, sucking some air into it I believe.
What would you do in this situation? My media is basically all peat and holds a ridiculous amount of water. Usually I just wait until the roots fill out and then droopy leaf’s stop.