Have you tried a local crafts store? Bamboo also grows near the pacific coast.
I have made diy bongs like I had mentioned in a prevous post I just made one out of a paintball pod. http://paintball-great.company.weiku.com/item/140-rounds-PAINTBALL-PODS-speed-tubes-paintball-equipment-14747619.html This kind of pod
As always on Riu there are disagreements over super important shit like I'm about to disagree with GG on .......there are infact two ways to fuck a bong ....let's not forget the hole on top of the old smoking vagina ......therefore it can be penetrated or it can penetrate ....the give and receive affect .......but thank you for the update @Grow_It_Roll_It_Light_It as I have been nervously and impatiently waiting news on the lost vagina/butthole bong ...I hope it's located and properly taken care of after you and your stoned friend were the last ones seen with it together
Thank you for the update il be standing by for more updates
I like to get high and fuck bongs too
Sounds an awful lot like a good ol Power Hitter!!
I guess that's why they made up that saying "there's more than one way to fuck a bong"
Gravity bongs are the easiest to make a 2 liter bottle and a small socket melt the cover enough to put the socket in and cut the bottom off the bottle then stick it in water put the cap on pack it light it pull up slowly take the cover off and rip that shit. I just made one last winter cut a hole in the ice and all.
I thought you said Power Hitler. I had a little twinge of anxiety.
Why?
Because extra Hitler.
1. Hack down some bamboo
Where there's lines in the bamboo, that's where it forms a seal on the inside. only the rest of the section is hollow. cut a few arm loads of wide, double and triple, sections and mail them back to the u.s.. Get some smaller sections for the stem, or bowls.
Dont listen to this turd cutter....he's on new mefication this week
