That Ohio Kidd
Well-Known Member
3.8g
smoked perfect hit like a champ
smoked perfect hit like a champ
me and friend roll a cross joint (pineapple express)
- Thread starter That Ohio Kidd
- Start date
buffalosoulja
Well-Known Member
NIICE....
DodgeDread
Well-Known Member
nice one!! how do you make those?
S
stoned88911
Guest
haha take a video of u smoking it
GregD88
Well-Known Member
theres a ton of vids on youtube
That Ohio Kidd
Well-Known Member
you just get 1 king size rolling paper and a regular one...roll a big spliff (cone) with the big one then roll a little pinner joint...take a paperclip and poke a hole through the big joint where you want the little one to be..then take your little joint and poke holes in it in the middle (so that joint hits once sealed) then put it thru the whole you made. seal up with a rollin paper! enjoy...its more simple tahn it sounds
That Ohio Kidd
Well-Known Member
we already smoked it lol the pics a day or two old
That Ohio Kidd
Well-Known Member
haha i know i know..but when you got that much weed in it (gooood tastin bud) you dont really taste the paper 
HoppusTheCaveman
Well-Known Member
looks better than mine haha
100's n 50's
Active Member
lol nice did it give you that trifecta you was looking for from the smokes colliding in the middle?
That Ohio Kidd
Well-Known Member
lol yes it did...it hit hard as hell until burnt passed the cross part then it was just a hell of a doobie
That Ohio Kidd
Well-Known Member
haha i got mine so all 3 ends burnt down to perfectly meet each other i have not a god damn clue how lol it kinda just happened its pry just the placement of the little guy sorryyy
Masterofgenetics
New Member
try to throw a half in joint.. sh*t is a waste.. cherry falls off every two seconds.. and then about half way it to soggy to even hold...
But on a different note have you ever used hash for a paper...
Call BS plz
But on a different note have you ever used hash for a paper...
Call BS plz
NewGrowth
Well-Known Member
No way dude you would have to be a cross joint engineer to do that.
jinmaster
Well-Known Member
LOL just make sure you got each end at a equal length from the middle n it normally is perfect.No way dude you would have to be a cross joint engineer to do that.
NewGrowth
Well-Known Member
They were equal lengthLOL just make sure you got each end at a equal length from the middle n it normally is perfect.
