Methods for yielding more BHO!

oh god!!!!!!!
this is one thing i know way too much about
first. NO PVC!!! i dont care what you read where! butane is an oil byproduct as long as thats true i dont want my extraction tube being any type of plastic.

you want a higher yeild? then you want a smaller tube.
do more runs with 8th to 1/4 oz tops in a GLASS tube!

thats all you can do for yeild, for quality you need a 2 stage vac pump rated to -31g at a 15 micron rating.
not cheap. and thats not all you need. but it will get you way above average.

theres a lot that goes into it, i posted an entire detailed tek in the concentrates thread, check it out.
 
I've found that after I run, if I put my tube in the freezer whilst waiting for some of the gas in go, the next run comes out even more yellow than the first. Which I guess is more goodness
 
Ter1 zip "strawberry licorice", 2 cans of "dodo 7x butane" , 1 seven inch long one inch diameter "steamroller" pipe modified for extraction, your preferred pyrex dish, and a plate warmer with settings as low as 100°. I run my product roughly 9 grams at a time with about 2/3s of a can in 15-20 second increments with about 5 seconds in between each spray. After youve run all your material, set your plate warmer around 100-125°place your dish on warmer and whip through the entire process. Roughly 15-20 minutes later i end up with anywhere from 5-8 grams of budder, this specific run was 7.4 grams.
20121016_193950.jpg
 
Ive also found that if i run my product a second time, the yield is about 1/2 and the quality goes down a little, first run budder second run peanut budder.. Still smokes good though, so 11 grams total on 2 runs of one zip..
 
You must log in or register to reply here.
Back
Top