MedHeadGRWR
Active Member
Basically I have a 92 site Aerocloner and I just redesigned my mother room. The mother room now has a split level where the top half holds 10 mothers (one 8 bulb 4 foot T5) and the bottom half will hold all the clones through vegetative state until they go into the flower room (one 2 bulb 4 foot T5 and one 8 bulb 4 foot T5). Basically for now the cloner is under just the 2 bulb T5 which hangs just about 14'' above the canopy (but can easily be adjusted if need be).
Room temps stay about 73 - 75 degrees and humidity levels vary anywhere from 40% to 55%.
This is my first run with this type of cloner and want to make sure I don't ruin 92 clones.
Basically I would like to know if these conditions will be sufficient. Do I need to keep humidity at a certain percentage???? Should I spray the clones with a mister? Should a humidity dome be used?
I did search and found some info but most people who were asking these sorts of questions gave vague descriptions of room conditions so I wanted to be as detailed as possible.
Thanks for the help and I will update tomorrow with pics of the clones' day one progress (cloner is full now).
Here is the cloner
Room temps stay about 73 - 75 degrees and humidity levels vary anywhere from 40% to 55%.
This is my first run with this type of cloner and want to make sure I don't ruin 92 clones.
Basically I would like to know if these conditions will be sufficient. Do I need to keep humidity at a certain percentage???? Should I spray the clones with a mister? Should a humidity dome be used?
I did search and found some info but most people who were asking these sorts of questions gave vague descriptions of room conditions so I wanted to be as detailed as possible.
Thanks for the help and I will update tomorrow with pics of the clones' day one progress (cloner is full now).
Here is the cloner