maineyankee
Active Member
I know that this may sound stupid, but I need some info. (Not too mechanically inclined here).
I am currently doing a DIY Cloner in a 19 gallon Rubbermaid Tote. I am using 3/4 inch pvc, and 360 Degrees E-Z Cloner Spray Jets. The water pump is a ArgoMax 250 GPH Model.
The questions that I have are as follows; (1) Do I end cap the PVC piece that is off the Tee in the middle and goes to the bottom of the tote? In doing so, I would imagine that I would run tubing from the pump, and into that one particular piece of PVC Pipe ... Correct? I also feel that I should prime with water, all of the PVC Pipes that comprise the outskirt of the cloner itself.
Thanks for the advice as it is always appreciated
The MaineYankee
I am currently doing a DIY Cloner in a 19 gallon Rubbermaid Tote. I am using 3/4 inch pvc, and 360 Degrees E-Z Cloner Spray Jets. The water pump is a ArgoMax 250 GPH Model.
The questions that I have are as follows; (1) Do I end cap the PVC piece that is off the Tee in the middle and goes to the bottom of the tote? In doing so, I would imagine that I would run tubing from the pump, and into that one particular piece of PVC Pipe ... Correct? I also feel that I should prime with water, all of the PVC Pipes that comprise the outskirt of the cloner itself.
Thanks for the advice as it is always appreciated
The MaineYankee