Resin

2fast92

2fast92

Well-Known Member
So I just cleaned my bowl and I didn't get any big blobs but I got a bunch of tiny little bits of really dry resin that if I put in my bolwl it would just fall through. Theres more than enough to get me baked but I need some advice on how to keep it together or soemthing to put it on to smoke.

Any ideas? Thanks
 
dam612

dam612

Well-Known Member
Just heat up a butter knife till warm and collect, the slight heat should clump it all together.
 
2fast92

2fast92

Well-Known Member
Those are all good ideas, thanks yall. And it IS resin. It's just really dried up because I found the piece and it hasn't been used in a loing time.
 
panhead

panhead

Well-Known Member
Why not just use a hot knife,i will smoke my oil like that once in a while when im too lazy to go fetch the proper gear,a blow torch & a rambo knife is how i smoke it in the garage
 
2fast92

2fast92

Well-Known Member
I just utp a little tobacco under the shit and took a hit, took it out, roll it into a ball and then put it ball in
 
Undercover Cop

Undercover Cop

Active Member
make a screen
take an aluminum can and cut a couple disks out of the aluminum using scissors, about the size of a quarter or nickel. with a pointy knife, carefully holding it by the tip of the blade pinched between your fingers (trying to describe the technique to hold the knife blade so you can make tiny little holes) poke a bunch of tiny holes in the aluminum disk, then pushing in the center I push that disk down into my bowl. Set yer resin on that and it will act like a screen and hold the resin off your bowl and will hold it in place, when it melts it will mostly spread out over the disk rather than melting down into your bowl and fouling it more.


happy festivus.jpgView attachment 1954912
festivus.jpg
 
You must log in or register to reply here.
Top