Roleadro 400w Cob Question

B

booboowilson

New Member
Hey y’all, so I bought a Roleadro with only one working led ($50). I replaced both of them with two CLU48-1212. Anyways, I was wondering if the fans only turn on when it reaches a certain temperature or if my fans are just broken? They move a tiny bit back and forth when turned on. I also took out two of the drivers if that makes a difference. Thanks!
 

Attachments

Boatguy

Boatguy

Well-Known Member
If you dont see any kind of sensor, or anything else attached to the fans, they should be running if the light is on. Do you see any spare wires besides the ones that power things?
 
B

booboowilson

New Member
Boatguy said:
If you dont see any kind of sensor, or anything else attached to the fans, they should be running if the light is on. Do you see any spare wires besides the ones that power things?
Click to expand...
Well you can see two yellow wires connected to one of the heat sinks

Edit: okay so I attached one of the led drivers I took out and it causes the fans to alternate on and off. The led driver it’s supposed to connect to is smaller and in the middle
 
Last edited:
fjbudboy

fjbudboy

Well-Known Member
I worked on one of these once as well, it does have a separate 12v driver, but I also had to replace both fans due to failure. They also ran 2 drivers per cob, so that sounds right that you didn't use half of them.
 
Airwalker16

Airwalker16

Well-Known Member
booboowilson said:
Doh, do you think it would be the fans of the driver?
Click to expand...
Well did you remove a small driver or two that happens connected to the fans? Follow the wires from them to the driver they're on. If it's wired and fans aren't turning on, the fans need to be replaced. I wouldn't use the cobs without them. They'll get too hot eventually and break.
 
B

booboowilson

New Member
Airwalker16 said:
Well did you remove a small driver or two that happens connected to the fans? Follow the wires from them to the driver they're on. If it's wired and fans aren't turning on, the fans need to be replaced. I wouldn't use the cobs without them. They'll get too hot eventually and break.
Click to expand...
No, both of the fans are connected to a single 12v driver. It most likely is the fans though. Guess I’ll get new ones and see if that works, thanks guys!
 
Airwalker16

Airwalker16

Well-Known Member
booboowilson said:
No, both of the fans are connected to a single 12v driver. It most likely is the fans though. Guess I’ll get new ones and see if that works, thanks guys!
Click to expand...
It's very possible it could instead be the driver. If you've got a multimeter, plug it in once you've cut the wire or unconnected the connector and test it to see if the drivers putting out 12v like it should. If not, meabwell has a driver for less than $10 called an APV-12-12. As long as you use .5A PC fans, that will run them both.
 
Last edited:
Olive Drab Green

Olive Drab Green

Well-Known Member
Isn’t Roleandro shit anyway? The Citizen COBs for the unit are a definite upgrade. At least you have a frame.

Fans are probably broken or disconnected. Nice modification!
 
Last edited:
B

booboowilson

New Member
Airwalker16 said:
Barely even $5.
Click to expand...
Thanks I'll check it out. I contacted the guy I bought it from so hopefully he can send some replacement parts (he didn't mention the broken fans in the description)

Olive Drab Green said:
Isn’t Roleandro shit anyway? The Citizen COBs for the unit are a definite upgrade. At least you have a frame.

Fand are probably broken or disconnected. Nice modification!
Click to expand...
Thank you!
 
You must log in or register to reply here.
Top