DWCgrower406
Well-Known Member
My room is all ready to switch over. Light has its own isolated venting, room has ac and dehumidifier. Already tested it sealed and i have no problem holding temp and humidity where i want without venting. Is there any other reason to vent occasionally if temp and humidity are good? What about at night? Just co2 off and plants are totally fine sealed?
Another question, i have solenoid regulator and ppm controller which i understand how to setup just fine, but the regulator has a flow rate adjustment. I assume high flow rate will result in a lot of on/off switching of the controller and you probably want it as low as you can get to minimize switching, but i have no idea where to start. I have a 5x5 room with a section to side, about 300 cubic feet. Is there an estimation of what flow rate i will need? Room is very well sealed. Walls sealed against concrete floor, door has gasket.
Another question, i have solenoid regulator and ppm controller which i understand how to setup just fine, but the regulator has a flow rate adjustment. I assume high flow rate will result in a lot of on/off switching of the controller and you probably want it as low as you can get to minimize switching, but i have no idea where to start. I have a 5x5 room with a section to side, about 300 cubic feet. Is there an estimation of what flow rate i will need? Room is very well sealed. Walls sealed against concrete floor, door has gasket.