Stelthy's 600W Hps Project! (New-Cab)

stelthy

stelthy

Well-Known Member
Ok its been a busy week or so and am almost ready for uploading an update. I've run into several complications but solved them... it's just taken a while, I plan on mounting the lid and front piece today so bare with me and wait for my next update :) - STELTHY
 
stelthy

stelthy

Well-Known Member


Ok aside from drinking to much I have been doing various house jobs for my missus, here is one of the long ass'd jobs I had to do...and do well... any way back to the important stuff, I have some new pics bringing my setup more up to date :) - STELTHY
 
stelthy

stelthy

Well-Known Member


Ok this is the dividing wall between the in-line fan and the carbon filter, I needed to mod it so I could get my hands around the neck of the filter to tape it on etc and then sound proof it.. Here I am drawing the 'doorway' :) - STELTHY
 
stelthy

stelthy

Well-Known Member


I positioned the hinges and screewed them into position (as its easier to do it this way) :) - STELTHY
 
stelthy

stelthy

Well-Known Member


I removed the doors again to cut a mid piece out so they would open and close propperly next to the filter also now I can sound proof it too - STELTHY
 
stelthy

stelthy

Well-Known Member


Some more ultra sticky sound deadening mat for the filter side - this will help to keep that side sterile :) - STELTHY
 
stelthy

stelthy

Well-Known Member


I stuck the sound deadening to the appropriate side and pricked holes where the hinges should go by the screw holes I had driven prior. This allowed me to mount the hinges and then cut out a section of mat to give me a metal to wood contact with the hinge :) - STELTHY
 
stelthy

stelthy

Well-Known Member


I labelled the doors at the edge so I knew which way to mount the after the mat had stuck - STELTHY
 
stelthy

stelthy

Well-Known Member


This is the lid, It was quite straight forward, all I had to do was draw around the sections when it was in place .. that allowed me to divide it into 3 then I had to sound proof 1 section with foam, 1 section with silver sound dead mat etc - STELTHY
 
stelthy

stelthy

Well-Known Member
I was pretty stoned when i did the cutting etc.. my Mrs went ape when she saw the cut marks in the table top lol, oh well I'll sand it down another day and re-varnish it...it will look even better than it origionaly did :) - STELTHY
 
stelthy

stelthy

Well-Known Member


This HUGE speaker grill will cover the filter hole I ve cut in the top section tidying it all up and stoping crap from falling in if I need to store things up there - STELTHY
 
You must log in or register to reply here.
Top