GiveMeKnowledge
Active Member
led gurus ... can I use 20mm tape to stick down 24mm wide strips? Tia.
Thermal tape sizing?
- Thread starter GiveMeKnowledge
- Start date
GiveMeKnowledge
Active Member
@Rocket Soul @Airwalker16 what you guys think?
GiveMeKnowledge
Active Member
cheers bud. I did think that, just wanted to be certain.
Rocket Soul
Well-Known Member
If its good tape, absolutely no prob. It its shitty, maybe not. Lately i had bad luck with tape and ended up having to go thru several tapes and just screwing it onto the sink.
GiveMeKnowledge
Active Member
I’ve seen some on amazon but if you have a link to some decent stuff I’ll get that. I could screw them if need be. Is it one or the other or do you tape and screw?
Rocket Soul
Well-Known Member
Tape and screw if you find the tape problematic. The strip also matters, plastic ones seems to lift the 2 ends a bit from the sink, especially the blux strips. Try the tape you got. I had best success with 3M brand and some construction tapes.
GiveMeKnowledge
Active Member
I have ali strips from cutter. I’ll tape and screw to be sure . Thanks. Ps might have to pick your brains about drivers later if that’s ok?
Rocket Soul
Well-Known Member
No probs, ill give advice if you tag me in a thread but i dont do driver tutorials over pms, its just too time consuming.
Also, cutter strips: solid metal, should work with tape only as long as the tape is good.
Also, cutter strips: solid metal, should work with tape only as long as the tape is good.
GiveMeKnowledge
Active Member
Yh sound . I’d rather keep it public anyway, might help other people at the same time.