What did you accomplish today?

UncleBuck · May 20, 2017

like, maybe there's a dead rodent in there?

Singlemalt · May 20, 2017

Muffler and environs for mud or other clumps. I'm serious here, if it sat a bit, mice make nests. Had shoulder surgery a few years ago, didn't drive my truck for about 1.5 months. When I started it, it was bogging bad, long story short, mice built a nest in the exhaust pipe, Unraveled a coat hanger and fished part of it out. Revved engine and blew rest out with some cooked micelings. Ran great

UncleBuck · May 20, 2017

Singlemalt said:
Muffler and environs for mud or other clumps. I'm serious here, if it sat a bit, mice make nests. Had shoulder surgery a few years ago, didn't drive my truck for about 1.5 months. When I started it, it was bogging bad, long story short, mice built a nest in the exhaust pipe, Unraveled a coat hanger and fished part of it out. Revved engine and blew rest out with some cooked micelings. Ran great

fucking knew it. those dead rodents trying to ruin my garden this year.

Singlemalt · May 20, 2017

I cut up aluminum window screen and make caps for all the exhaust pipes I have

UncleBuck · May 20, 2017

Just checked in there and blew it out with my air compressor. Nyet.

Singlemalt · May 20, 2017

Spark plug?

UncleBuck · May 20, 2017

Singlemalt said:
Spark plug?

took it out and gapped it earlier, no difference.

Singlemalt · May 20, 2017

Sounds and feels regular until load. correct?

UncleBuck · May 20, 2017

Singlemalt said:
Sounds and feels regular until load. correct?

yep. although when i lift the tines into the air and let it out full throttle the engine tries to cut out and stall too.

Singlemalt · May 20, 2017

Can you test compression?

UncleBuck · May 20, 2017

Singlemalt said:
Can you test compression?

not sure i have the tools to do that. doubt it's in the engine either. just bought it last year.

Singlemalt · May 20, 2017

Check online for the engine specs, a comp tester isn't that much ($10 for basic and on up for better ones). Also I assume you checked air intake for clogs, impediments

UncleBuck · May 20, 2017

i'm gonna take another crack at that bitch tomorrow. then i'll just take it to jesus.

Singlemalt · May 20, 2017

What brand? If you have aluminum cylinders and or piston rings oil is crucial, they get worn/scoured easy

whitebb2727 · May 20, 2017

Olive Drab Green said:
If not, help me convince her to get a puppy for the kid to grow up with.

Every kid needs a puppy.

Mine have always been around dogs. My youngest, a toddler, is thick as thieves with our boxer. Best friends.

tangerinegreen555 · May 20, 2017

UncleBuck said:
not sure i have the tools to do that. doubt it's in the engine either. just bought it last year.

A year old engine should run like a champ. You're positive you have good gas?

UncleBuck · May 20, 2017

tangerinegreen555 said:
A year old engine should run like a champ. You're positive you have good gas?

i was so unsure of it that i bought the ethanol free pre-mixed shit just in case my gas can had remnants of old gas in it seemed to help a little but still cuts out and bogs down at full throttle or under load.

Singlemalt · May 20, 2017

Jets maybe then, fuel adjustment is off

UncleBuck · May 20, 2017

Singlemalt said:
What brand? If you have aluminum cylinders and or piston rings oil is crucial, they get worn/scoured easy

it's a little 43cc two stroke from home depot. not sure the brand.

Singlemalt · May 20, 2017

It's a 2 cycle? what brand

What did you accomplish today?

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Similar threads