iliketolearn
Well-Known Member
This is just the area and equipment for the flowering room...
THE ROOM:
Its a backyard shed that is sandwiched between the side of my house and the neighbor's fence
My landlord was cheap and used the side of my house as one of the lengthwise walls
There is no insulation just bare 2x4's every 16 in on center
The roof has a lengthwise pitch 8 inches higher at one end(see artist's rendition")
The entrance to the shed is in the back yard(obviously)
58" x 96" x 81"(short end) - 89"(tall end)
I will be running lights off of a washer/dryer dedicated circuit. Everything else will be on another dedicated circuit.
Here's what I have :
LIGHTS
1 x 1000 WATT HPS MAGNETIC BALLAST
1 x 1000 WATT HPS/MH SWITCHABLE MAGNETIC BALLAST
3 x 150 WATT HPS MAGNETIC BALLASTS
AIR
1 x 400 CFM HYDROFARM ACTIVE AIR EXHAUST FAN(its old but has never been used) 115 WATT
1 x 5000 BTU HAIER (cools area 1000 - 1500 cubic ft) 450 WATT
1 x DIY AIR SCRUBBER(can't remember details but I know it's will suffice for this room)
WATER
1 x QMAX 1276 G/H ECOPLUS SUBMERSIBLE PUMP 14.7 HMAX 90 WATT
I wanted to do 2 side by side vertical bulbs
exhaust the heat from directly above the lights through ducting(or cool tubes if it becomes a necessity) into scrubber through ACTIVE AIR EXHAUST FAN out of the top of the shed.
for the heat I wanted to install the HAIER window AC into the upper portion of the shed
I have all the equipment for and would like to do a RECIRCULATING DEEP WATER CULTURE. I've set one up before but I never ran plants through it.
How would you suggest I position and setup the equipment?
Thanks in advance,
iliketolearn
THE ROOM:
Its a backyard shed that is sandwiched between the side of my house and the neighbor's fence
My landlord was cheap and used the side of my house as one of the lengthwise walls
There is no insulation just bare 2x4's every 16 in on center
The roof has a lengthwise pitch 8 inches higher at one end(see artist's rendition")
The entrance to the shed is in the back yard(obviously)
58" x 96" x 81"(short end) - 89"(tall end)
I will be running lights off of a washer/dryer dedicated circuit. Everything else will be on another dedicated circuit.
Here's what I have :
LIGHTS
1 x 1000 WATT HPS MAGNETIC BALLAST
1 x 1000 WATT HPS/MH SWITCHABLE MAGNETIC BALLAST
3 x 150 WATT HPS MAGNETIC BALLASTS
AIR
1 x 400 CFM HYDROFARM ACTIVE AIR EXHAUST FAN(its old but has never been used) 115 WATT
1 x 5000 BTU HAIER (cools area 1000 - 1500 cubic ft) 450 WATT
1 x DIY AIR SCRUBBER(can't remember details but I know it's will suffice for this room)
WATER
1 x QMAX 1276 G/H ECOPLUS SUBMERSIBLE PUMP 14.7 HMAX 90 WATT
I wanted to do 2 side by side vertical bulbs
exhaust the heat from directly above the lights through ducting(or cool tubes if it becomes a necessity) into scrubber through ACTIVE AIR EXHAUST FAN out of the top of the shed.
for the heat I wanted to install the HAIER window AC into the upper portion of the shed
I have all the equipment for and would like to do a RECIRCULATING DEEP WATER CULTURE. I've set one up before but I never ran plants through it.
How would you suggest I position and setup the equipment?
Thanks in advance,
iliketolearn
Last edited: